Справочник Пользователя для Mitsubishi Electronics FX5

15  MEMORY CARD FUNCTION
15.2  Boot Operation

After the SD memory card has turned to disable status, release the SD memory card forced stop status by the operation 
shown below.

Load SD card again.

Turn OFF

ON the power or reset the CPU module.

*1 The CARD READY LED will blink

light up.

The precaution regarding SD memory card forced stop is described below.
 • When a forced stop operation is carried out by SD memory card disable switch and forced stop operation by SM606, 

operation carried out earlier becomes valid, and the operation that is carried out later becomes invalid. For example, after 
the forced stop by SD memory card disable switch, when SM606 is turned ON

OFF without removing the SD memory 

card, the disable status of the SD memory card can be released. After the forced stop by SD memory card disable switch, 
when SD memory card is removed and then SM606 is turned ON, SM606 operation is ignored.

At the time of power OFF

ON or reset of the CPU module, a file which is stored on the SD memory card is transferred to the 

memory of the transfer destination which the CPU module judged automatically.

The selectable files for boot operation are listed below.

Carry out the boot file settings.

Load SD memory card.

Write the boot file settings and boot file to the SD memory card.

Turn OFF

ON the power or reset the CPU module.

The procedure of boot operation is explained below.
 • Parameter files (system parameters, CPU parameters, module parameters, module extension parameters)
 • Remote password
 • Global labels (global label setting files, initial label values)
 • Program files (programs, restored information)
 • FB files (FB, restored information)
 • Device comments
 • Initial device values