Справочник Пользователя для Mitsubishi Electronics FX5
19 BUILT-IN I/O FUNCTION
19.2 FX3-compatible high-speed counter function
167
19
• If the UDCNTF instructions and HIOEN instructions are used for the same CH, it is not possible to use the
HIOEN instruction to stop the high-speed counter started by UDCNTF instructions. On the other hand, the
instruction started by the HIOEN instruction can be stopped by executing ON
instruction started by the HIOEN instruction can be stopped by executing ON
OFF of UDCNTF
instructions. Use caution when the HIOEN instruction and UDCNTF instructions are used together.
• Do not drive the same LC device number at the same time.
The operation of each element of the current value of a started counter and the LC
device
device
Shown below is the operations of the SD device, the current value of the LC device, and each element of the LC device when
the counting is started with UDCNTF instructions or is started with the HIOEN instruction while the FX3 compatible function is
valid.
the counting is started with UDCNTF instructions or is started with the HIOEN instruction while the FX3 compatible function is
valid.
: Operate
: Not operate
: Not operate
• When a count is started by HIOEN instruction, although LC device changes, neither a counting coil nor the
counter contact operates. Moreover, when operation is started by HIOEN instruction and LC
corresponding to CH is reset, during the RST instruction ON, operation is stopped and calculation is
resumed in OFF of the RST instruction.
corresponding to CH is reset, during the RST instruction ON, operation is stopped and calculation is
resumed in OFF of the RST instruction.
Assignment for FX3-compatible high-speed counters
The high-speed counter number that can be specified with each CH
Shown here are the high-speed counter numbers (C235 to C255) of FX3 that can be selected with each CH
The current value of the SD device, each element of the LC device
The start with UDCNTF
instruction
instruction
The start with HIOEN
instruction
instruction
The current value of the SD device
The current value of the LC device
The LC device counting coil
The counter contact point of the LC device
The reset coil of the LC device
CH
High-speed counter No.
Pulse input mode
Corresponding devices
Preset input logic change
CH1
C235
1-phase 1-count (S/W)
LC35
CH1
C241
1-phase 1-count (S/W)
LC41
CH1
C244
1-phase 1-count (S/W)
LC44
CH1
C246
1-phase 2-count
LC46
CH1
C247
1-phase 2-count
LC47
CH1
C249
1-phase 2-count
LC49
CH1
C251
2-phase 2-count (1 edge count/4 edge count)
LC51
CH1
C252
2-phase 2-count (1 edge count/4 edge count)
LC52
CH1
C254
2-phase 2-count (1 edge count/4 edge count)
LC54
CH2
C236
1-phase 1-count (S/W)
LC36
CH3
C237
1-phase 1-count (S/W)
LC37
CH3
C242
1-phase 1-count (S/W)
LC42
CH3
C245
1-phase 1-count (S/W)
LC45
CH4
C238
1-phase 1-count (S/W)
LC38
CH4
C248
1-phase 2-count
LC48
CH4
C248 (OP)
1-phase 2-count
LC48
CH4
C250
1-phase 2-count
LC50
CH4
C253
2-phase 2-count (1 edge count/4 edge count)
LC53