Справочник Пользователя для Mitsubishi Electronics FX5

(Read these precautions before use.)
Before using this product, please read this manual and the relevant manuals introduced in this manual carefully and pay 
attention to safety in order to handle the product correctly.
This manual classifies the safety precautions into two categories: [

WARNING] and [

CAUTION].

Depending on the circumstances, procedures indicated by [

CAUTION] may also cause severe injury.

It is important to follow all precautions for personal safety.
Store this manual in a safe place so that it can be read whenever necessary. Always forward it to the end user.

[DESIGN PRECAUTIONS]

● Make sure to set up the following safety circuits outside the PLC to ensure safe system operation 

even during external power supply problems or PLC failure. Otherwise, malfunctions may cause 
serious accidents.
 -  Most importantly, set up the following: an emergency stop circuit, a protection circuit, an interlock 

circuit for opposite movements (such as forward vs. reverse rotation), and an interlock circuit to 
prevent damage to the equipment at the upper and lower positioning limits.

 -  Note that when the CPU module detects an error, such as a watchdog timer error, during self-

diagnosis, all outputs are turned off. Also, when an error that cannot be detected by the CPU 
module occurs in an input/output control block, output control may be disabled. External circuits 
and mechanisms should be designed to ensure safe machine operation in such a case.

 -  Note that the output current of the 24 V DC service power supply varies depending on the model 

and the absence/presence of extension modules. If an overload occurs, the voltage automatically 
drops, inputs in the PLC are disabled, and all outputs are turned off. External circuits and 
mechanisms should be designed to ensure safe machine operation in such a case.

 -  Note that when an error occurs in a relay or transistor of an output circuit, the output might stay on 

or off. For output signals that may lead to serious accidents, external circuits and mechanisms 
should be designed to ensure safe machine operation.

● Construct an interlock circuit in the program to ensure safe operation for the whole system when 

executing control (for data change) of the PLC in operation.
Read the manual thoroughly and ensure complete safety before executing other controls (for program 
change, parameter change, forced output and operation status change) of the PLC in operation.
Otherwise, the machine may be damaged and accidents may occur due to erroneous operations.

● In an output circuit, when a load current exceeding the current rating or an overcurrent caused by a 

load short-circuit flows for a long time, it may cause smoke and fire. To prevent this, configure an 
external safety circuit, such as a fuse.

● For the operating status of each station after a communication failure of the network, refer to relevant 

manuals for the network. Incorrect output or malfunction may result in an accident.

Indicates that incorrect handling may cause hazardous conditions, resulting in 

death or severe injury. 

Indicates that incorrect handling may cause hazardous conditions, resulting in 

minor or moderate injury or property damage.