Справочник Пользователя для Mitsubishi Electronics -NZ2GF2B-60DA4

101

CHAPTER 8 FUNCTION

8.12  T

rigger 

Outpu

t Function

  

Using this function, the D/A converter module performs the D/A conversion at the timing of a trigger output request.

● This function can be used only when the drive mode is set to the trigger output mode.
● The D/A converter module converts analog values into digital values in all the channels where the D/A conversion is 

enabled, every time Trigger output request (RY19) is turned on.

Using this function with the external signal assignment function enables the D/A conversion by the trigger output 
request at when the remote input signal of the extension input module is turned on.
For the external signal assignment function, refer to the following.

 • External signal assignment function (

An extension input module is required when the trigger output function is used with the external signal assignment function.

The following table lists the restrictions on the trigger output function.

After the D/A conversion-enabled channel is set and Initial data setting request flag (RY9) is turned on and off, 
the D/A converter module waits for trigger input.
Once Trigger output request (RY19) is turned on, the D/A converter module performs the D/A conversion for all 
the channels where the D/A conversion is enabled.

Shift function

Cannot be used.
The setting of CH Shifting set value (RWw6 to RWw9) will be ignored.