Справочник Пользователя для Mitsubishi Electronics -NZ2GF2B-60DA4

28

D/A conversion enable/disable function

Whether to enable or disable D/A conversion can be set for each channel.
Disabling the D/A conversion for unused channels reduces the 
conversion cycles.

D/A output enable/disable function

Whether to output the D/A conversion value or the offset value can be set 
for each channel.
The conversion speed is constant, regardless of the output 
enable/disable status.

Range switching function

The output range can be selected for each channel from the following 
ranges:

• Factory default range (4 to 20mA, 0 to 20mA, 1 to 5V, 0 to 5V, -10 to 

10V)

• User range (user range setting 1, user range setting 2)

Offset/gain setting function

This function compensates for errors in analog output values.

Analog output HOLD/CLEAR function

Whether to hold or clear the output analog value can be set, according to 
the CPU module operating status (RUN, STOP, or stop error).

Cyclic data update watch function

The update intervals of cyclic data are monitored. The last output value is 
held or cleared when the cyclic transmission stop status continues longer 
than the set monitoring time.

Scaling function

The D/A converter module scale-converts the digital value to the set 
range of the scaling upper limit value and scaling lower limit value. The 
programming for scale conversion can be reduced.

Shift function

Using this function, the D/A converter module outputs the converted 
digital value with the shifting set value added, in analog. Fine adjustment 
can be performed easily when the system starts.

Digital value range check function

An error is output when the digital value is out of the digital input range for 
the output range.

Alert output function

This function outputs alert when a digital value is in the range set in 
advance.

Trigger output function

Using this function, the D/A converter module performs the D/A 
conversion at the timing of the execution of Trigger output request.
Trigger output request from the external device to the extension input 
module can be used for the D/A conversion.

CC-Link IE Field Network synchronous 
communication function

With this function, the D/A converter module can perform D/A conversion 
synchronized with the operation cycle of a simple motion module. This 
enables the D/A converter module to operate at the same timing of other 
slave stations on the same network.

Error notification function

When a moderate error or major error occurs in the D/A converter 
module, this function notifies the master station of the error with the 
remote input signal.

Function at the extension module installation

One extension I/O module can be connected to one D/A converter 
module.
Remote input signals of the D/A converter module can be assigned to 
remote output signals of the connected extension output module. In 
addition, functions unique to the extension I/O module can be used.

CC-Link IE Field Network diagnostic function

With this function, whether any network error occurs or not can be 
checked through GX Works2 connected to the CPU module.