Справочник Пользователя для Sony RDR-VX511
107
Additional Information
, Turn the power off and unplug the AC power
cord.
, The program that starts first has priority and the
second program starts recording only after the
first program has finished. If the programs start
at the same time, the program listed first in the
menu has priority (page 77).
first program has finished. If the programs start
at the same time, the program listed first in the
menu has priority (page 77).
The
c
indicator flashes after timer recording is
set.
, Check that the safety tab has not been removed.
The SYNCHRO REC indicator flashes after
Synchro-Recording is set.
Synchro-Recording is set.
, Check that the safety tab has not been removed.
Display
Menus or displays do not appear on the
screen.
screen.
, While the recorder is reading disc information,
the System Menu, TOOLS menu, or information
display will not appear.
display will not appear.
“- -:- -” appears in the front panel display.
The
c
indicator is flashing.
, The disc does not have enough space.
, Insert a recordable disc or a tape with its safety
, Insert a recordable disc or a tape with its safety
tab in place inside the recorder.
Remote control
The remote does not function.
, Batteries are weak.
, The remote is too far from the recorder.
, The remote’s code returned to the default setting
, The remote is too far from the recorder.
, The remote’s code returned to the default setting
when you replaced the batteries. Reset the code
(page 19).
(page 19).
, Turn on the recorder.
, The remote is not pointed at the remote sensor on
, The remote is not pointed at the remote sensor on
the recorder.
, Different command modes are set for the
recorder and remote. Set the same command
mode (page 24).
mode (page 24).
, Slide the TV/DVD·VIDEO switch to
DVD·VIDEO (page 20).
Other Sony equipment responds to the remote.
, The same command mode is set for both the
Sony DVD equipment. Set a different command
mode for the recorder (page 24).
mode for the recorder (page 24).
Others
The recorder does not operate properly.
, Restart the recorder. Press down "/1 on the
recorder for more than ten seconds until “SONY
DVD” appears in the front panel display.
DVD” appears in the front panel display.
, When static electricity, etc., causes the recorder
to operate abnormally, turn off the recorder and
wait until the clock appears in the front panel
display. Then, unplug the recorder and after
leaving it off for a while, plug it in again.
wait until the clock appears in the front panel
display. Then, unplug the recorder and after
leaving it off for a while, plug it in again.
The disc tray does not open after you press
Z
Z
OPEN/CLOSE.
, It may take a few seconds for the disc tray to
open after you have recorded or edited a disc.
This is because the recorder is adding disc data to
the disc.
This is because the recorder is adding disc data to
the disc.
The disc tray does not open and “TRAY
LOCKED” appears in the front panel display.
LOCKED” appears in the front panel display.
, Contact your Sony dealer or local authorized
Sony service facility.
“CAN NOT RECORD BECAUSE OF HIGH TEMP.”
appears in the front panel display.
appears in the front panel display.
, Check that the vent on the rear of the recorder is
not blocked. Then, turn off the recorder, wait
until the clock appears in the front panel display,
and disconnect the AC power cord. Leave the
recorder off for a while, then re-connect the
power cord, and press "/1 on the recorder.
until the clock appears in the front panel display,
and disconnect the AC power cord. Leave the
recorder off for a while, then re-connect the
power cord, and press "/1 on the recorder.
“CHILD LOCK” appears in the front panel
display.
display.
, The recorder is locked. Cancel the Child Lock
Control by AV mouse is not possible.
, Some satellite receivers may not support AV
mouse.