Справочник Пользователя для Sony RDR-VX511

Follow steps 1 to 7 to hook up and adjust the 
settings of the recorder.

• Plug cords securely to prevent unwanted noise.
• See the instructions supplied with the components to be 

connected.

• You cannot connect this recorder to a TV that does not 

have a video input jack.

• Be sure to disconnect the power cord of each 

component before connecting.

Check that you have the following items:
• Audio/video cord 

(phono plug 

× 3 y phono plug × 3) (1)

• Antenna cable (1)
• Remote commander (remote) (1)
• Size AA (R6) batteries (2)

Select one of the following antenna hookups. Do 
not connect the power cord until you reach 
“Connecting the Power Cord” on page 19.

This reminder is provided to call the CATV 
system installer’s attention to Article 820- 40 of 
the NEC that provides guidelines for proper 
grounding and, in particular, specifies that the 
cable ground shall be connected to the grounding 
system of the building, as close to the point of 
cable entry as practical.

• If your antenna is a flat cable (300-ohm twin lead 

cable), use an external antenna connector (not 
supplied) to connect the antenna to the recorder.

• If you have separate cables for VHF and UHF 

antennas, use a UHF/VHF band mixer (not supplied) to 
connect the antenna to the recorder.

Cable box or satellite receiver with a 
video/audio output

Cable box with an antenna output 
only

Cable without cable box, or antenna 
only (no cable TV)