Справочник Пользователя для Sony HDW-D1800

48

5-1  Automatic Editing

  Chapt

er 5  Edit

in

g

When you carry out automatic editing, the recorder and 
player operate as shown in the figure above, to record the 
video and audio signals between the IN and OUT points on 
the player to the segment between the IN and OUT points 
on the recorder.

Monitor output
Like in the preview, duing an automatic editing, you can 
monitor the video and audio signals as follows on a 
monitor connected to the recorder.
• From the preroll point to the IN point, you can monitor 

the playback image from the recorder.

• From the IN point to the OUT point, you can monitor the 

playback image from the player through the recorder in 
E-E mode.

• From the OUT point to the postroll point, you can 

monitor the playback image from the recorder.

The following figure illustrates the descriptions above.

You can edit efficiently even if only one monitor is 
available, by using the following procedure.

Connect the monitor to the recorder.

In the basic setup menu, set menu item 008 to 
“AUTO”.

Select the player (PLAYER) using F6 (R/P SEL) in 
function menu page P06: EDIT on the recorder side.

This makes the recorder forcibly enter the E-E mode, 
and the player video and audio signals are output to the 
monitor.

Tape transport

Preroll point

Recording overlap 
(in case of assemble 
editing)

IN point

OUT point

Postroll point

Preroll

Edit segment

Postroll

Stop

Time flow

Stop

Playback

IN point

OUT point

Playback 
(recorder)

E-E mode 
(player)

Playback 
(recorder)