Инструкция для Sony SLV-N60
66
Searching for a selected point on the tape (SLV-N60/AX20 only)
To cancel searching
Press H PLAY or x STOP.
To turn off the bar indication
Press DISPLAY again.
Notes
• The figure on the bar indication represents the total time length of the inserted tape as shown
below.
The total time length may not be displayed correctly for:
– Tapes other than T-60, T-120, or T-160.
– Tapes recorded in more than one tape speed mode.
The total time length may not be displayed correctly for:
– Tapes other than T-60, T-120, or T-160.
– Tapes recorded in more than one tape speed mode.
• If you move the pointer (F) on the bar indication while searching, the VCR searches for the
new reset point.
• With the bar indication on, the M
FF/
, and m
REW/
< buttons on the remote
commander work only for moving the pointer (F), while the M
FF and m
REW
buttons on the VCR are used for normal tape operation. Note, however, if you press these
buttons on the VCR, searching is canceled.
buttons on the VCR, searching is canceled.
2
Press
</, to move the pointer (F) to the point
where you want to start playback.
The VCR starts searching and the cursor (x)
moves toward the pointer. When the VCR locates
the marked point, playback starts.
moves toward the pointer. When the VCR locates
the marked point, playback starts.
Tape type
Total time length
SP
LP
EP
T-60 or shorter
60
120
180
from T-80 to T-140
120
240
360
T-160 or longer
160
320
480
0
1 2 0