Справочник Пользователя для Sony HVR-M25AU

84

Chapter 6

Maintenance

Cha

p

te

r 6

M

ai

nt

e

nan

ce

Even though KEY INH switch is set to ON, 
the unit responds to operations input using 
the Remote Commander.

• Setting the KEY INH switch to ON does not disable the Remote Commander. To 

disable the Remote Commander, set [COMMANDER] in the [OTHERS] menu to 
[CONTROL S] (page 80).

Whenever you connect the unit to an AC 
outlet, the unit turns on automatically.

• [AC ON MODE] in the [OTHERS] menu is set to [ON].

t Set [AC ON MODE] to [STANDBY] (page 81).

• There is a cassette inside the unit and the TIMER switch is set to REPEAT or 

REC.
t Set the TIMER switch to OFF (page 7).

No picture on the LCD monitor.

• [LCD BLACK] in the [DISPLAY SET] menu is set to [ON].

t Set it to [OFF] (page 75).

• With an analog connection, the current setting of [60i/50i SEL] in the [OTHERS] 

menu is not appropriate.
t Set it to the appropriate position for the device you are using (page 82).

The power cannot be turned on.

• The AC power cord is disconnected.

t Connect the AC power cord.

• The KEY INH switch is set to ON.

t Set the switch to OFF (page 6).

• The POWER switch on the rear of the unit is in the “a” position (OFF).

t Press the “|” marked side of the POWER switch (ON) (page 20).

The unit will not operate even if the power 
has been turned on.

• The KEY INH switch is set to ON.

t Set the switch to OFF.

• Moisture condensation has occurred (page 94).
• The cassette is not inserted straight.

t Eject and reinsert it correctly.

t Disconnect the power supply and then reconnect it after about 1 minute. If the 

unit does not operate even after you reconnect the power, use a sharp-tipped 
ballpoint pen or similar tool to press the RESET button. When you press the 
RESET button, all settings, including the date, time, and 60i/50i are initialized 
(page 20).

The cassette cannot be inserted.

• There is moisture condensation on the head drum (page 94).

t With the unit powered on, wait more than one hour.

• The cassette is not inserted straight.

t Eject and reinsert it correctly.

• Another cassette has been loaded already.

t Remove the cassette and insert the one you want to load.

It takes time to eject the cassette.

• This is not a malfunction.

t The unit ejects the cassette slowly to protect the tape. While the cassette is 

being ejected, the q (cassette) indicator blinks.

The cassette tape is not ejected when you 
press the EJECT button.

t Check whether the power supply is connected properly.
• The KEY INH switch is set to ON.

t First, set the switch to OFF(page 6), then eject the casette.

• Moisture condensation has occurred in the unit (page 94).