Справочник Пользователя для Sony SRW-5000

111

5-4 Playback

  Chap

ter
 5

  Rec

o

rd

ing/

Pla

y

b

a

c

k

the VTR SETUP menu item 101 “SELECTION FOR 
SEARCH DIAL ENABLE”.

When playing back the same program on two VTRs, you 
can adjust the playback phases of the two VTRs so that 
they are synchronized.
There are two ways to make this adjustment:
(A) Using the search dial
(B) Using the +/– buttons

When using method (A), change the system setup so that 
jog/shuttle mode playback is inhibited even when the 
search dial is rotated. Doing so prevents the VTR from 
accidentally entering jog/shuttle mode during capstan 
override playback. 
Set the VTR SETUP menu item 101 “SELECTION FOR 
SEARCH DIAL ENABLE” to “via search key”.

Use either method (A) or (B).

(A) Rotate the search dial while holding down the 

PLAY button to adjust the playback speed.
The adjustment range is ±15% (in steps of 1%) of 
the normal playback speed.

(B) Press the + or – button while holding down the 

PLAY button to adjust the playback speed.
Every time the + or – button is pressed, the speed 
changes by 1 frame.

During playback at increased or decreased speed, the 
SERVO indicator goes off since the servo is not locked 
(capstan override).

Release the PLAY button after you have finished 
adjusting the phase.

The VTR returns to normal-speed playback and the 
SERVO indicator lights up.

DMC (Dynamic Motion Control) playback allows you to 
vary the playback speed in variable mode (in the DT 
playback range from –1 to +2 times normal speed)  for 
certain sections of the tape, then store the specified speed 
in memory for later playback.
For example, during a live broadcast of a sporting event, 
you can set the start and end points of important scenes 
while recording, and immediately play back and broadcast 
those scenes using DMC playback. 

Follow the procedure below to store DMC playback 
speeds in memory.

In the HOME menu, press the ALT/[F7] (DMC) 
buttons to light up DMC on the display.

Set a start point during recording or on a previously 
recorded tape by simultaneously pressing the ENTRY 
button and the IN button.

Press the STOP button to enter stop mode.

Rotate the search dial to select the initial playback 
speed.

The selected speeds are shown in the time data display 
window in the menu display.

If the VTR SETUP menu item 101 “SELECTION 
FOR SEARCH DIAL ENABLE” is set to “dial 
direct”, initial speed settings cannot be made. Change 
the setting of this menu item to “via search key”.

Press the PREROLL button and PREVIEW/REVIEW 
button simultaneously.