Справочник Пользователя для Sony SLV-SE250B

12

Tuning your TV to the VCR

filename[010get.fm] model name1[SLV-SE250B] model name2[SLV-SE450B]

 [3-868-346-E2 (1)]

Set the TV to the video channel and press CHAINE +/– on the VCR.  If the TV 
screen changes to a different programme each time you press CHAINE +/–, the TV 
tuning is correct. 

If the screen does not appear clearly in step 6 above, go to step 7 to finish this 
procedure once.  Then start again from step 2.  After pressing REGL CANAL in step 
2, press CHAINE +/– while the RF channel is displayed, so that another RF channel 
appears.  Then tune the TV to the new RF channel so that a clear picture appears.

Press CHAINE +/– (repeatedly) to select the appropriate TV system for 
your area.

Select “L” for the L TV system (SECAM), or “G” for the B/G TV system 
(PAL).

Tune the TV to the same channel shown in 
the VCR display window so that the 
picture on the right appears clearly on the 
TV screen.

Refer to your TV manual for TV tuning 
instructions.

If you select the wrong TV system in step 
5, the picture on the right may not appear.  
Select the appropriate TV system and tune 
the TV again.

If the picture does not appear clearly, see “To obtain a clear picture from the 
VCR” below. 

Press REGL CANAL.

You have now tuned your TV to the VCR.  Whenever you want to play a 
tape, set the TV to the video channel.

CHAINE

ALIGNEMENT

MAGNETOSCOPE SONY

REGLAGE AUTO

REGL CANAL

010COV.book  Page 12  Friday, April 14, 2000  1:07 PM