Справочник Пользователя для JVC LPT0808-001B

Page 4

July 17, 2003 8:53 am

— 4 —

A

Make sure the package contains all of the accessories listed in 
“Specifications” (

墌

16).

B

Place the recorder on a stable, horizontal surface.

C

A Disconnect the TV aerial cable from the TV.

B Connect the TV aerial cable to the ANT. IN terminal on the 

rear of the recorder.

C Connect the supplied RF cable between the RF OUT terminal  

on the rear of the recorder and the TV’s aerial input terminal.

(improves picture quality during tape playback.)
If your TV is equipped with AV input connectors
A Connect the aerial, recorder and TV as shown in the 

illustration.

B Connect an AV cable between the AUDIO/VIDEO OUT 

connectors on the rear of the recorder and the AV input 
connectors on the TV.

● Even if you are using AV cables to connect your recorder to 

your TV, you must also connect it using the RF cable. This will 
ensure that you can record one show while watching another.

D

Plug the mains power cord into a mains outlet.

Video channel (RF output channel) is the channel on which your TV 
receives picture and sound signals from the video recorder through 
the RF cable. Before performing the following steps, make sure the 
recorder’s power is off and there is no cassette inserted in the 
recorder.

If you have connected the video recorder to your TV via the 
provided RF cable only (RF connection)...
A Hold down 0 on the recorder until 

the display panel shows the following.

B Press PR r or t on the remote control 

to set appropriate TV system that 
matches the system of TV being used 
(refer to the table below).
1:B/G  2:D/K  3:I  4:H 

C Set your TV to UHF channel 36.

● If the two vertical white bars appear clearly on 

the screen as shown on the right, press OK or e 
and then go to step 

D.

● If the two vertical white bars do not appear clearly, 

press OK and then PR r or t to set the recorder to a vacant 
channel between 28 and 60 which is not occupied by any local 
station in your area.

 

(Ex.) If channel 50 is available in your area...
Then set your TV to UHF channel 50 and check if the two vertical 
white bars appear clearly on the screen; if so, go to step 

D. If not, 

re-set the recorder to another vacant channel and try again.

D Press OK or e to finish video channel set.

If you have connected the video recorder to your TV via both the 
provided RF cable and an AV cable (AV connection)...
A Hold down 0 on the recorder until 

the display panel shows the following.

B Press OK or e, then press PR t until 

the display panel shows the following.
Now the video channel is set to off (– –).

C Press OK or e to finish video channel 

set.

RF cable
(supplied)

Back of recorder

Mains power cord

AV cable
(not supplied)

To AV input 
connectors

TV aerial cable

Mains outlet

To aerial terminal

TV

New Zealand, Kuwait, U.A.E., Indonesia, 

Singapore, Thailand, Malaysia, Iran, Saudi 

Arabia, Egypt, Morocco, Lebanon, Iraq 

B/G

China, Mongolia, Russia

D/K

Hong Kong

I

Australia

H

If Auto Set Up or Tuner Set has not previously been performed, 
the Language Select screen appears and Auto Set Up function 
takes place automatically.

HR-V400AG-EN.fm  Page 4  Thursday, July 17, 2003  8:53 AM