Справочник Пользователя для Invacare 1061057
46
WARNING
Make sure the detent pin and locking pins of the
quad-release axle are fully released BEFORE op-
erating the wheelchair.
quad-release axle are fully released BEFORE op-
erating the wheelchair.
Keep locking pins clean.
6. Flip the handle of the quad-release axle down to
release the detent pin ensuring that the locking
pins are fully released.
pins are fully released.
7. If detent pin does not fully release, proceed to AD-
JUSTING THE QUAD-RELEASE HANDLE.
8. Repeat STEPS 1-7 for the opposite rear wheel.
ADJUSTING THE QUAD-RELEASE
HANDLE (FIGURE 4)
HANDLE (FIGURE 4)
In and/or Out
1. Remove rear wheel and the quad-release axle
from the wheelchair.
2. Loosen the locking screw.
3. Make the following adjustments:
If the quad-release handle is not releasing the
locking pins completely, rotate the quad-re-
lease handle approximately one-quarter (1/4)
turn CLOCKWISE.
locking pins completely, rotate the quad-re-
lease handle approximately one-quarter (1/4)
turn CLOCKWISE.
If the quad-release handle hits the spokes of the
rear wheel when assembled, rotate the quad-re-
lease handle approximately one-quarter (1/4)
turn COUNTERCLOCKWISE.
rear wheel when assembled, rotate the quad-re-
lease handle approximately one-quarter (1/4)
turn COUNTERCLOCKWISE.
4. Tighten the locking screw.
5. Reinstall the rear wheel and quad-release axle onto
the wheelchair.
FIGURE 3 - INSTALLING THE QUAD-RELEASE
AXLE
Quad-Release
Axle
Rear Wheel Hub
Locking Collar
Allen Screw
Axle Mounting
Plate
IN/AND
OR OUT
OR OUT
Locking Screw
Locking Pins
Axle Mounting Plate
Quad-Release
Handle
INSTALLING THE QUAD-RELEASE AXLE
(FIGURE 3)
(FIGURE 3)
1. Remove rear wheel and the existing quick-re-
lease axle from the wheelchair.
2. Remove the existing quick-release axle from the
rear wheel hub.
3. Insert the new quad-release axle through the
rear wheel hub.
4. Slide the locking collar onto the quad-release
axle until it is snug against the rear wheel and
tighten securely with the allen screw.
tighten securely with the allen screw.
5. Reinstall rear wheel and the quad-release axle
onto the wheelchair.
WARNING
Make sure the detent pin and locking pins of
the quick-release axle are fully released BE-
FORE operating the wheelchair.
the quick-release axle are fully released BE-
FORE operating the wheelchair.
Keep locking pins clean.
5. Reinstall rear wheel onto the wheelchair.
PROCEDURE 6
REAR WHEELS
R
E
A
A
R
W
H
E
E
E
L
S
FIGURE 4 - ADJUSTING QUAD-RELEASE AXLE
Detent
Pin
Locknut
Locking
Pins
Axle Mounting
Plate
Quick-Release Axle
Wheel Hub
FIGURE 2 - ADJUSTING THE QUICK-RELEASE
AXLE
Length Adjustment Screw
REMOVING PLAY
FROM THE REAR
WHEELS
FROM THE REAR
WHEELS