Справочник Пользователя для Motorola G24

Chapter 3: AT Commands Reference

December 31, 2007

AT Commands Reference Manual

3-389

+MIPOPEN: 2,1

// Listen socket over TCP:

AT+MIPOPEN=1,1100,"0.0.0.0",0,0 // Listens to any port at any IP.

+MIPOPEN: 1,1,122.221.32.64,1200// Remote side connected to the listen socket.

AT+MIPOPEN=3,3212,"122.1.222.134",0,0 // Listen to any port at specific IP.

+MIPOPEN: 3,1,122.1.222.134,1222// Remote side connected to the listen socket.

//SSL

AT+MIPOPEN=2,2222,"www.google.com",443,2 // TCP secured with SSL

+MIPOPEN: 2,2

AT+MIPOPEN=3,1234,"www.xyz.com",443,2 // TCP secured with SSL

+MIPSSL: 3,15// SSL_UNKNOWN_CA alert

+MIPOPEN: 3,2

+MIPODM, Open a Socket (UDP or TCP) in Online Data Mode

This command causes the G24 to initialize a new socket that waits for a connection from a remote
machine or opens a common or TCP secured with SSL connection with a remote side (according
to received parameters) and switch it to Online (raw data transfer) Data Mode and open a
connection with a remote side.

Notes:

MIPxxx is a complete set of GPRS commands. This set should not be used with other

GPRS commands, such as CGATT, CGACT, and so on.

Online Data Mode allows the user to transfer raw data from terminal to Network and vice
versa over a GPRS channel. Currently, only RS232 connection to terminal with hardware
flow control is supported.

Each socket allocates an accumulating buffer whose size is 1372 bytes. When the user
sends amount of data, less then buffer size, the data is being sent to Network after a
spooling timeout (200 mS), otherwise the data is being sent to Network immediately.

Only one socket is allowed at the same time in Online Data Mode.

The +MIPODM command returns a +MIPSTAT <Socket ID><Error> unsolicited event
if it fails. For example, if it was rejected by the remote side.

The +MIPODM command returns a +MIPSSL unsolicited event(s) in case of alert(s)
occurring during secure connection establishment or in pseudo-command mode. See

Table 3-280