Справочник Пользователя для Motorola G24
Chapter 3: AT Commands Reference
December 31, 2007
AT Commands Reference Manual
3-439
The following table shows the +CMUX parameters.
Note:
Due to non-ERM, the <k> parameter is not supported.
MUX Modes
The <mode> parameter in the +CMUX command determines whether the MUX protocol works
in Basic mode or Advanced mode, including the transparency mechanism. When the G24
changes states from PREMUX to MUX-Init, the G24 opens the MUX stack in the selected mode.
in Basic mode or Advanced mode, including the transparency mechanism. When the G24
changes states from PREMUX to MUX-Init, the G24 opens the MUX stack in the selected mode.
In Advanced mode the following requirements apply:
•
The length field is no longer be a part of the new frame structure.
•
A transparency mechanism.
•
XON/XOFF flow control is available.
Table 3-289: +CMUX Parameters
<Parameter>
Description
<mode>
MUX mode:
0 Basic
1
0 Basic
1
Advanced
<subset>
Defines how the MUX control channel is set up. The virtual channel is set up
according to this setting.
0
according to this setting.
0
UIH frames used only
<port_speed>
Transmission rate:
1
1
9600 bit/sec
2
19200 bit/sec
3
38400 bit/sec
4
57600 bit/sec
5
115200 bit/sec
6
230400 bit/sec
7
460800 bit/sec
<N1>
Maximum frame size:
31
31
256
The default value is 31 in Basic mode, 64 in Advanced mode.
<T1>
Acknowledgement timer (in units of 10 ms).
1-255 Default value is 10 (100 ms)
1-255 Default value is 10 (100 ms)
<N2>
Maximum number of retransmissions.
0-100 Default value is 3
0-100 Default value is 3
<T2>
Response timer for the DLC0 (in unit of 10 ms). <T2> must be longer than <T1>.
2-255 Default value is 30 (300 ms)
2-255 Default value is 30 (300 ms)
<T3>
Wake up response timer (in seconds).
1-255 Default value is 10.
1-255 Default value is 10.