Руководство Пользователя для Panasonic 700

Chapter 3. System Features

Section 700 - Operation  

Page 3-42

DBS Manual - Revised April 2000

DBS-2.3/9.2-700

(All Versions)

The DBS can be programmed from a remote terminal or from a remote PC. 
Remote programming can be accomplished using the Remote Programming 
Mode or by using Panasonic’s PCAS (Personal Computer Administration 
System) or DBS Manager software.

(All Versions)

Remote Programming Mode uses a “dumb” terminal or a PC to access the 
DBS. This method of remote maintenance is less sophisticated and more 
difficult than using PCAS or DBS Manager.

You can enter the Remote Programming Mode through any of these three 
methods:

• By using a local PC and communications package to connect directly to 

the DBS serial port

• By dialing into the system through a direct DISA trunk

• By dialing into the system through a regular CO trunk, then requesting the 

operator to enter the Remote Programming ID Code.

When programming from a terminal connected to the RS-232C (SMDR) port, 
perform the following steps:

1.  Make certain the cables are configured and connected as outlined in 

Section 300.

2.  Make certain the DBS is in the SMDR mode by entering the following 

code from the attendant port:

ON/OFF #93

3.  Enter your terminal communications program and make sure your PC’s 

data communications settings match those of the DBS.