Справочник Пользователя для Pelco C1300M-C (11/08)
C1300M-C (11/08)
25
Quick Programming Guide
(See Page 9)
AZIMUTH ZERO
Azimuth is the pan angle from 0 to 359 degrees. Azimuth zero is the pan position you specify to be
the 0-degree point. Azimuth zero is normally set to magnetic north. Once set, azimuth and compass
readings are based on the set Azimuth Zero point.
the 0-degree point. Azimuth zero is normally set to magnetic north. Once set, azimuth and compass
readings are based on the set Azimuth Zero point.
To program azimuth zero:
1.
Use the joystick to position the cursor beside SET AZIMUTH ZERO.
2.
Press Iris Open.
3.
Follow the directions displayed on the monitor.
To clear azimuth zero:
1.
Use the joystick to position the cursor beside CLEAR AZIMUTH ZERO.
2.
Press Iris Open.
3.
Follow the directions displayed on the monitor.
EXIT
LANGUAGE
ENGLISH
UNIT INVERSION
OFF
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<UNIT SETTINGS>
<POSITION CALIBRATION>
<DISPLAY SETUP>
<UNIT SETTINGS>
<POSITION CALIBRATION>
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
CYCLE CAMERA POWER
REBOOT SYSTEM
PELCO EXSITE IPSXM
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<WIPER>
<AUX>
<CLEAR>
<PASSWORD>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<WIPER>
<AUX>
<CLEAR>
<PASSWORD>
BACK
EXIT
EXIT
UNIT SETTINGS
PROPORTIONAL PAN
ON
PARK TIME (MINUTES)
0
PARK ACTION
NONE
SCAN SPEED (DEG/S)
25
PRESET FREEZE FRAME
AUTO
LIMIT STOPS
ON
<SET MANUAL STOPS>
<CLEAR MANUAL STOPS>
<SET SCAN STOPS>
<CLEAR SCAN STOPS>
<CLEAR MANUAL STOPS>
<SET SCAN STOPS>
<CLEAR SCAN STOPS>
<SET AZIMUTH ZERO>
<CLEAR AZIMUTH ZERO>
<CLEAR AZIMUTH ZERO>
BACK
EXIT
EXIT
REFERENCE INFORMATION
MANUAL LIMITS SET
MANUAL LIMITS SET
NO
SCAN LIMITS SET
NO
MOTION