Справочник Пользователя для Kodak VERSION 4.0

K O D A K   D i s p l a y   M a n a g e r   S y s t e m   V 4 . 0   U s e r ’ s   G u i d e

     

 1 1

Before connecting the hardware, install the software.

The Display Manager System hardware consists of an enable cable and 
sensor. Purchase the sensor that is appropriate for your system configuration. 
See 

 to learn about the sensors supported by 

the Display Manager System.

If you do not have enough available USB ports, use a USB hub when 
connecting the enable cable and sensor.

If you must run the cables long distances, you may need to purchase a Port 
Authority device and additional cables.

(WINDOWS) After you connect the hardware, click Next when the Found New 
Hardware Wizard opens. Follow the on-screen prompts. If you are prompted to 
locate the drivers:

•

SEQUEL drivers are found in C:\Progam Files\Kodak\KODAK Display 

Manager System\SequelDrivers.

•

X-RITE drivers are found in C:\Progam Files\Kodak\KODAK Display 

Manager System\XRiteDrivers.

For digital projectors, MINOLTA CS-100A or PHOTO RESEARCH PR-650 
sensors are recommended.

The enable cable allows the computer to talk to the monitor. It connects to the 
monitor port, a USB port, and then to the monitor cable. 

You may need a DVI to HD15 pin adapter depending on your configuration. 

(WINDOWS 2000 only) If you unplug the enable cable or sensor and then plug 
it back in, the system will not recognize it until you restart your computer. 

Connect to the 
monitor cable

Connect to a USB 
port

Connect to the 
computer monitor port