Справочник Пользователя для Plus M-11S

Number of Copies

If any of the following flashing indications appear in the display window of the 
control panel, please check the matters described below. 
The flashing will continue for 5 seconds. Error messages will flash for 5 sec-
onds; however, error displays of “E4” and “E5” will be lit steadily after the 
flashing stops.

•  Is the printer cable connected? 
•  Is power being supplied to the printer?
•  When the printer uses an AC power adapt-

er, is the cable disconnected somewhere?

•  Connect the printer properly and switch on 

the printer power.

•  Has paper been set in the printer? 

•  Insert A4 or Letter size paper into the 

printer.

•  Is the printer error indicator flashing (or lit)?  •  Read the printer instruction manual.

•  Is the USB memory unformatted. 

•  This unit supports the FAT 12/16 and FAT 

32 formats. Perform the formatting with the 
personal computer. 

•  Is a USB memory that is not supported by 

the copyboard being used? 

•  Please see our home page for information 

about USB memories that can be used 
with the copyboard.

•  Is the USB memory device plugged in 

fully?

•  Is the USB memory damaged?

•  Please check the operation with a personal 

computer.

•  An error occurred during USB memory 

storage. 

•  Please perform USB memory storage 

again. 

•  Do not insert or remove the USB memory 

during processing.

•  There is a lighting fault of the reading light 

source, or a read signal error.

•  Unplug the power plug from the power out-

let and then plug it in again. 

•  There is a memory or internal fault. 

•  Unplug the power plug from the power out-

let and then plug it in again. 

•  The pages are not being properly detected. •  Unplug the power plug from the power out-

let and then plug it in again. 

•  USB memory device is not plugged into the 

main unit.

•  Plug the USB memory device into the USB 

port.

•  Did you press the ON/Standby 

 button 

while the USB memory device was plugged 
into the main unit?

•  A USB memory device is plugged into the 

main unit. When the USB memory device 
is disconnected, the power will be switched 
off and the unit will enter the standby 
mode. 

•  There is no available space.

•  Please delete unnecessary data using a 

personal computer (See Page E-27).

•  A printer that is not supported by the copy-

board has been connected. 

•  Press the ON/Standby 

 button and 

switch off the power. When a record is 
required, switch on the power and save to 
USB memory.

If the problem persists, please contact your nearby PLUS Vision sales office, dealer, or store.