Справочник Пользователя для TEAC HD-P2

The HD-P2 features a headset jack and phones adjust 
knob. In the Project Menu, Settings page there is an 
option for choosing the type of headset monitoring. 
The choices include Stereo, Mono Left, Mono Right, 
Mono Summed, and Follow Record Mode. The Mono 

Summed mode can be useful if you are doing mono 
recordings sometimes from the left and sometimes the 
right. Follow Record Mode sets the headphone moni-
toring mode to match the project’s channel settings.

When the HD-P2 detects low power or low media 
space it flashes the appropriate icons on the main 
screen. In some situations, when the screen isn’
t within line of sight or being monitored, you may 
want to enable audible alerts. This is an option in the 
System Menu. When enabled and an alert condition 

happens, a series of beeps are sent to the audio output 
jacks and the headset. A short series of beeps indicates 
a warning while a longer series indicates a more seri-
ous problem, which will soon be followed up by the 
system stopping recording (media space low) or shut-
ting down (battery power low).

This is the screen you will see when the HD-P2 is first 
powered up, and is the main screen for operating and 
monitoring the HD-P2. 

Metering – Instantaneous metering values (playback & 

record) along with peak decay and clip indicators. 

The response rate and peak hold times are configu-

rable in the Project, Settings menu.

Timeline – Current time in hours:minutes:seconds:

tenths/sec in non-timecode mode, hours:minutes:

seconds:frames in timecode mode.

Scrub point – Indicates the unit that is changed when 

the scrub wheel is rotated. This will affect the reso-

lution of the Scrub wheel.  Change this by pressing 

+

.

Current – Current project, file, and marker. File and 

marker are based on timeline location and will ap-

pear/disappear accordingly.

Pre-Record – Percent of the pre-record buffer filled. 

Pre-record size varies from ten seconds down to 

five, depending on sample rate. This bar is updated 

in Monitor mode only when pre-record is enabled.

Settings – Current project settings in effect.
Timecode – On/Off, when On it shows some timecode 

settings.

Locator – Current (or last) locator position and name. 

Pressing both Locate L&R together will relocate 

the timeline to this locator.

Power – Power source: AC adapter, FireWire, or bat-

tery (with level).

Lock – Shown when the 

 switch is engaged, all 

other buttons are disabled.

Clock – Time of day clock, used for file creation time. 
Transport – Icons showing the current transport state.
FireWire – Indicates the HD-P2 is connected to a 

computer via FireWire, not mounted.

Time display– Displays the remaining time left for  

recording on the media.

The Power and Transport sections of the screen change 
their icons based on their current state. The Power and 

Disk icons will blink whenever either approaches a 
low power or disk threshold, respectively.