Листовка для Insignia NS-CLIP01

Congratulations on your purchase of a 
high-quality Insignia product. Your 
NS-CLIP01 represents the state of the art in 
clock radios with an iPod/iPhone dock and 
is designed for reliable and trouble-free 
performance.

•  Clock radio with iPod/iPhone dock
•  AC power adapter
•  AAA batteries (2)
•  Quick Setup Guide

1  Open the battery compartment on the bottom of 

your radio.

2  Place two AAA size batteries in the battery 

compartment.

  Make sure to match the + and - on the battery to 

the + and - signs in the battery compartment.

3  Close the battery compartment until it clicks into 

place.

1  Plug the small connector at the end of the power 

cord into the DC IN 5.9V jack on the back of your 
radio.

2  Plug the AC adapter into a 100-240V, 50/60Hz 

power outlet.

The clock radio enters standby mode and the time 
appears on the display.

1  In standby mode, press and hold 

POWER/SOURCE to turn on the clock radio. The 
Source name appears in the upper left-hand 
corner of the display.

2  When you turn on the clock radio for the first 

time, iPod mode activates by default.
For normal use, the system activates the last 
source used before you powered it off.

3  Press and hold POWER/SOURCE again to switch 

to standby mode. The Source name is no longer 
displayed. 

•  After you select the mode you want, press 

Volume + or Volume - to set the volume to a 
comfortable level.

Note: When the volume is turned to minimum (00), 
the system enters MUTE mode.

Quick Setup Guide

•  The two AAA batteries are only for the clock memory. When battery power is low, or if they 

are installed incorrectly, the             logo shows on the display. Change or reinstall the 
batteries.

•  Please remove the batteries if your clock radio is not used for a long time.

•  Use only the size and type of batteries specified.

•  Do not mix different types of batteries together (e.g., alkaline, rechargeable, and standard 

(carbon zinc), or old batteries with fresh ones.

•  Exhausted batteries must be removed to prevent any battery leakage.

•  Dispose of batteries properly according to environmental regulations.

•  Battery (battery pack or battery installed) shall not be exposed to excessive heat, such as 

sunshine, fire, or the like.

1 Dock

2 

3 

4 

         /Preset

5 Tune

6 Tune

7 

8 

9 

10  ANT 

11  CLOCK/SYNC

12  AUX IN jack

13  DC IN 5.9V jack

Insert your iPod/iPhone into this dock to play selections through your clock radio.
The clock radio charges the iPhone/iPod when docked. Use the adapter that came with your 
iPod/iPhone, if needed.

Press to set the alarm. See 

Setting the alarm on the right.

Press to turn on the Sleep timer  (15, 30, 45, 60, 75, 90). To turn off, press until “00” appears on 
the display.

•  In iPod mode, press to begin playback. Press again to pause playback. Press again to resume 

playback. Press and hold to turn off your iPod/iPhone screen.

•  In FM mode, press to select a preset station. Continue pressing to cycle through the available 

preset stations. You can store up to 10 preset stations.

•  In iPod mode, press to go to the previous track, or press and hold to use fast back.
•  In FM mode, press to go to the next lower radio frequency, or press more than one second 

and release to search for a lower radio station.

•  In iPod mode, press to go to the next track, or press and hold to use fast forward.
•  In FM mode, press to go to the next higher radio frequency, or press more than one second 

and release to search for a higher radio station.

Press to increase or decrease the clock radio volume.

Press while the alarm is sounding to turn the alarm off for 10 minutes. You can do this as many 
times as you want.
To turn the alarm off until the next day, press any other button. 
To turn the alarm off, press the Alarm button until there is no source displayed next to the 
alarm icon on the display.
When the alarm is not sounding, press to cycle through the display brightness levels 
(high>middle>low).
Note: When the clock radio is turned on, the LCD backlight defaults to High.

Press and hold to turn on your clock radio. Press and hold to turn off your clock radio.
When your clock radio is on, press to cycle through the sound sources (iPod, RADIO, AUX).

Extend the antenna to improve reception.

Press to set the time or sync the time with an iPhone. See 

Using the Time Sync function on the 

right.

Plug the connector from an external sound source, such as an MP3 player, into this jack.

Plug the small connector from the AC adapter into this jack.

1 Press and hold Clock/Sync for two seconds until the hour blinks on the 

display.

2 Press Tune        or        to set the hour.
3 Press the Clock/Sync button again. The minutes blink on the display. 
4 Press Tune        or        to set the minutes.
5  To finish setting the clock, press the Clock/Sync button again, or just 

wait for ten seconds until the display returns to normal.

1  Place your iPod/iPhone in the docking station.

2 Press the Clock/Sync button. The clock radio syncs the time with the 

iPod/iPhone automatically.

Note: The Time Sync function can be used with most of the iPod/iPhone 
models, except some older models such as iPod mini, iPod 3G, and iPod 4G.

• Press 

SOURCE repeatedly to select iPod, Radio, or AUX. The source 

you select appears on the display.

1  Press the Alarm button to select the alarm music source 

(Buzzer/Radio/iPod) or close the alarm.

  If you select iPod, make sure your iPod/iPhone is placed in the dock. If 

you select Radio, the alarm will be the last radio station you listened to.

2  Press and hold ALARM 1 or ALARM 2 until the hour digits blink.

3 Press Tune        or        to set the hour, then press the ALARM 1 or 

ALARM 2 button. The minutes digits blink.

4 Press Tune        or        to set the minutes, then press ALARM 1 or 

ALARM 2 to save the setting and exit the alarm setting mode.

1  When the alarm is sounding, press any key (except SNOOZE/DIMMER) 

to turn off the alarm. The alarm is set for the next day.

2  If you do not want to set the alarm for the next day, press ALARM 1 or 

ALARM 2 repeatedly until the alarm icons disappear from the display.

•  While the alarm is sounding, press SNOOZE/DIMMER. The SNOOZE 

indicator appears in the display. The alarm turns on automatically ten 
minutes later.

Notes:

•  If the alarm is set to Buzzer, the alarm volume gradually increases until it 

reaches the maximum.

•  If the alarm is set to Radio or iPod, the volume starts from Volume 1 and 

gradually increases to the volume level setting before the clock radio 
was turned off.

•  The alarm sounds for 20 minutes and then shuts off automatically.

•  If two alarms are set, the first alarm is stopped (set for the next day) 

when the second alarm time is reached.