Справочник Пользователя для Datexx RC224W

PROGRAMMING THE SNOOZE INTERVAL

* Press and hold SET1 button for two seconds to

activate an Alarm1 programming mode. Alarm1 hour

digit will flash.

* Adjust the desired hour using UP ( ) or DOWN ( )

buttons.

* Press SET1 button: the minute digits will flash.

* Adjust the desired minutes using UP ( ) or

DOWN ( ) buttons.

* Press SET1 button again:

the snooze interval minutes

will flash.

* Adjust the desired interval time using UP ( ) or

DOWN ( )buttons.

* Press SET1 button to confirm set snooze interval.

Use the same procedure to program the snooze interval

for Alarm2.
INDOOR TEMPERATURE

The indoor temperature shares the same display’s line

with the calendar and the day of the week.

NOTE: If the indoor temperature goes above or below

operating range stated in specifications, the display will

show dashes [ ].

SETTING THE ALARM

To set the Alarm1,

* Press MODE button once to display

ALARM TIME 1. If the alarm is off,

the default time “6:00” will be

displayed.

* Press and hold SET1 button for two

seconds. The hour digit will flash.

* Enter the hour using DOWN ( ) or

UP ( ).

* Press SET1 button again.

The minute digits will flash.

* Enter the minutes using DOWN ( )

or UP ( ).

* Press SET1 button again to

confirm:

an icon [ ] will appear on the

display next to the alarm time.

* Repeat the same procedure to set an

Alarm2, using SET2 button.

LIGHT/SNOOZE

When the alarm sounds, press the LIGHT/SNOOZE

button to temporarily stop the alarm. After the LIGHT/

SNOOZE is depressed, the alarm sound will resume in

five minutes.

If the alarm is not disabled after that, it will sound for

four more minutes and then will stop by itself.
DISABLING ALARM

Press SET1 or SET2 buttons on the unit to disable any of

the alarms.

When Alarm1 and Alarm2 are disabled, an applicable

icon [ ] or [ ]will disappear from the unit’s display.

TIME FORMAT

* Press UP ( ) button to toggle

between 12 and 24 hour time format

DAY OF THE WEEK LANGUAGE

* Press and hold DOWN ( ) button

for 3 seconds: the default language

abbreviation will flash (example – EN)

* Continue holding DOWN ( )

button until the desired day of the

week language abbreviation is

selected.

* Release the DOWN ( ) button to

confirm the setting.

ALARMS

There are two available alarms –Alarm 1 and Alarm 2.

If any of alarms is activated, it will sound at the set time

and the alarm icon will flash Mondays through Fridays.

PRECAUTIONS

This product is engineered to give you years of satisfactory

service if handled carefully. Here are a few precautions:

* Do not immerse the unit in water.

* Do not clean the unit with abrasive or corrosive

materials. They may scratch the plastic parts and

corrode the electronic circuits.

* Do not subject the product to excessive force, shock,

dust, temperature, or humidity, which may result in

malfunctions, shorter lifespan, damaged batteries, and

damaged parts.

* Do not tamper with the unit’s internal components.

Doing so will invalidate the warranty and may cause

damage. The unit contains no user-serviceable parts.

* Use only fresh batteries. Do not mix new and old batteries.

* Read the user's manual thoroughly before operating

the unit.

New

Moon

Waning

Crescent

Waning

Crescent

First

Quarter

Waxing

Gibbous

Full

Moon

Waning

Gibbous

Last

Quarter

1
2

MOON PHASE

Moon phase indicator is displayed in accordance with

the calendar.

1
2