Справочник Пользователя для American Dryer Corp. AD-464

450260-1

www.amdry.com

Notes

For proper cable (wire rope) routing, starting at the

piston;

A. Replace the cable (wire rope) thimble and wire rope

clamp to one side of the cable.

B. Secure the cable (wire rope) to the piston mount with

the 3/8-16 x 1" bolt, 3/8" fender washer, 3/8" lock washer,

and 3/8-16 hex nut.

C. Feed the cable (wire rope) through the cylinder clevis

assembly and around the outer lower right cable

pulley, to the upper right cable pulley, to the inner lower

right cable pulley, to the inner lower left cable pulley, to

the outer lower left cable pulley, and to the cylinder

clevis assembly.

D. Feed the cable (wire rope) through the wire rope clamp.

E. Feed the cable (wire rope) thimble through the

turnbuckle adjustment rod.

F. Feed the cable (wire rope) around the wire rope thimble.

G. Feed the end of the cable (wire rope) through the wire

rope clamp and tighten.

H. Adjust the turnbuckle to the proper cable (wire rope)

tension.

8. To install new cable (wire rope), reverse Step #7 through

Step #3.

9. Reestablish the air supply to the dryer.

10. Reestablish electrical service to the dryer.

Load Door Glass Window Replacement

1. Remove all of the old silicone from around the door

glass.

2. Clean glass door opening (with alcohol) to remove all

foreign residue.

3. Carefully clean new door glass with alcohol prior to

installation.

4. Apply a bead of silicone (ADC P/N 170730) to the outer

perimeter of the door glass opening.

5. Carefully insert new door glass within the door glass

opening.

Important

Allow a full 72 hours for the silicone to cure.

6. Carefully trim excess silicone (with a razor blade) after

the cure time.

4. Remove the two (2) 1/4" x 1/4" poly connectors from the

piston.

5. Loosen the turnbuckle so that the cable becomes slack.
6. Loosen the setscrew securing the cylinder clevis

assembly to the piston shaft.

7. Remove the 5/16-24 x 1/4" socket head cap screw and

5/16" lock washer from the piston base.

8. Unscrew the piston shaft from the cylinder clevis

assembly.

9. To install new door piston, reverse Step #8 through Step

#3.

10. Reestablish the air supply to the dryer.

11. Reestablish electrical service to the dryer.

Cable (Wire Rope) Replacement

1. Discontinue electrical service to the dryer.
2. Discontinue the air supply to the dryer.
3. Block the bottom load door in the closed position prior

to disassembly of any parts.

Important

Failure to block the bottom load door securely in the

closed position may result in personal injury.

4. Loosen the turnbuckle so that the cable becomes slack.
5. Remove the two (2) cable (wire rope) clamps from the

wire rope.

6. Loosen the four (4) cable (wire rope) clamp plates from

the wire rope.

7. Remove the cable (wire rope).