Справочник Пользователя для Beko DCU 7230

8 EN

A

 Prior to installation, visually check if the 

product has any defects on it. If so, do not 

have it installed. Damaged products will 

cause risks for your safety.

•  Install the product in an environment 

which has no risk of freezing and is in a 

stable and level position.

•  Operate your product in a well ventilated, 

dust-free environment.

•  Do not block the air ducts in front of and 

under the product with materials such as 

long pile rugs and wooden plinths.

•  Do not place your product on a long pile 

rug or on similar surfaces.

•  Do not install the product behind a door 

with a lock, sliding door or a hinged door 

which can strike the product.

•  Once the product is installed, it should 

stay at the same place where its 

connections have been made. When 

installing the product, make sure that the 

rear wall of it does not touch anywhere 

(tap, socket, etc.) and also pay attention 

to install the product at a place where it 

will stay permanently.

B

 Do not place the product on top of the 

power cable.

•  Keep at least 1.5 cm distance to walls of 

other furniture.

A

Remove the transportation safety 

assembly before using the product for 

the first time.

1.  Open the loading door.

2.  There is a nylon bag inside the drum that 

contains a piece of styrofoam. Hold it 

from its section marked with XX.

3.  Pull the nylon towards yourself and 

remove the transportation safety 

assembly.

A

Make sure that you have removed 

the transportation safety assembly 

(nylon+styrofoam pieces) before using 

the product for the first time. Do not 

leave any items inside the drum.

•  A special part (Part no. 297 360 0100) 

replacing the top trim can be provided 

and installed by the Authorised Service 

Agent in order fit the machine under a 

low counter or in a cupboard. It should 

never be operated without the top trim.

•  Leave at least 3 cm of space between 

the side and rear walls of the product 

and the walls of the counter/cupboard 

when installing your product under a 

counter or in a cupboard.

•  A fitting device should be used between 

the two machines when installing above 

a washing machine. The bracket must 

be installed by the Authorised Service 

Agent.

•  Place the product on a firm floor. If 

it will be placed on top of a washing 

machine, the approximate weight of 

both machines may reach 180 kg when 

they are full. Therefore, the floor must be 

capable of carrying the load on it!

In products equipped with a condenser unit 

the water accumulated during the drying 

cycle is collected in the water tank. You 

should drain the accumulated water after 

each drying cycle.

You can directly send the accumulated water 

out through the water drain hose supplied