Справочник Пользователя для Maytag MGD5100DC

7

Steam Boost

Steam Boost adds steam to the end of the Heavy Duty, Bed-

ding, or Normal cycle to help smooth wrinkles. Steam Boost can 

be used with High or Medium heat settings. This option adds 

approximately 15 minutes to the total cycle time.
Cycle Signal

Use this to turn the signal indicating the end of a drying cycle on 

or off.
NOTE: You may also turn off the tones that sound when  

a feature, setting, or option is touched. Touch and hold Cycle 

Signal for about one second to turn sounds on  

or off.
Control Lock

Use to lock the controls of the dryer and avoid  

an accidental change in cycle options or preferences during a 

drying cycle.
Touch and hold CONTROL LOCK for 3 seconds to lock or 

unlock the controls of the dryer. During this time, the LED 

Display will count down 3-2-1. Once the controls  

are locked, the LED Display will display “Lc” or “Loc.”
NOTE: The Control Lock function may be enabled when 

recovering from a power failure. To unlock the control, touch and 

hold CONTROL LOCK for at least 3 seconds.

The Cycle Status Indicators show the progress of a cycle. Not all 

indicators are available on all models.

Sensing
  The Sensing indicator will light during Sensor Cycles to  

indicate that the moisture sensor on the dryer is operating. This 

indicator will not light during Timed Cycles or options such as 

Wrinkle Prevent.

Check Vent
  This indicator will show the status of airflow through the dryer 

and the dryer vent system for the dryer’s life. During the sensing 

phase at the beginning of the cycle, the Check Vent light will 

come on if a blocked vent or low airflow issue is detected. This 

light will stay on for the entire cycle. The light will be cleared 

when selecting a new cycle, touching POWER, or opening the 

door after the cycle has completed. This feature is available 

during Sensor and Steam cycles only. For more information 

on maintaining good airflow, see “Check Your Vent System for 

Good Airflow”.

  

NOTE: If there are other error issues during a cycle, the Check 

Vent indicator will not light up. See “Troubleshooting” section.

Good Airflow
  This indicator will light if there is no major vent blockage.

Steaming
  This indicator will light when a steam function is active. 
  NOTE: Steam is not available on all cycles. 

 Done
  This will indicate that the selected cycle has ended and the load 

may be removed from the dryer. If Wrinkle Prevent has been 

selected, the dryer may continue to tumble the load, even if  

the Done indicator is lit.

Check Lint Screen
  The Check Lint Screen indicator will light when the drying  

cycle is complete as a reminder to clean the lint screen. 

Appearance may vary.

6