Справочник Пользователя для JVC GR-D338AH

MasterPage: Left

To attach the camcorder 
to a tripod, align the 
direction stud and screw 
to the mounting socket 
and stud hole on the 
camcorder. Then tighten 
the screw clockwise.

● Some tripods are not 

equipped with studs.

The camcorder needs to be powered up to load 
or eject a cassette. 

Slide and hold OPEN/EJECT in the direction 

of the arrow, then pull the cassette holder cover 
open until it locks. The cassette holder opens 
automatically.

÷ Do not touch internal components.

Insert or remove a tape and press “PUSH” to 

close the cassette holder. 

÷ Be sure to press only the section labelled “PUSH” 

to close the cassette holder; touching other parts 
may cause your finger to get caught in the 
cassette holder, resulting in injury or product 
damage.

÷ Once the cassette holder is closed, it recedes 

automatically. Wait until it recedes completely 
before closing the cassette holder cover.

÷ When the battery pack’s charge is low, you may 

not be able to close the cassette holder cover. Do 
not apply force. Replace the battery pack with a 
fully charged one or use AC power before 
continuing.

Close the cassette holder cover firmly until it 

locks into place.

To protect valuable recordings
Slide the erase protection tab on the back of the 
tape in the direction of “SAVE”. This prevents the 
tape from being recorded over. To record on this 
tape, slide the tab back to “REC” before loading 
it.

● If you wait a few seconds and the cassette holder 

does not open, close the cassette holder cover 
and try again. If the cassette holder still does not 
open, turn the camcorder off then on again.

● If the tape does not load properly, open the 

cassette holder cover fully and remove the 
cassette. A few minutes later, insert it again.

● When the camcorder is suddenly moved from a 

cold place to a warm environment, wait a short 
time before opening the cassette holder cover. 

GR-D338AH_EN.book  Page 16  Wednesday, January 25, 2006  5:45 PM