Справочник Пользователя для Veo 802.11b

Page 47 of 69 

Press and hold the Power button down for 6 seconds to reset the camera to the 
factory defaults. You will see “300” displayed in the IP Address LCD display to 
indicate that the camera has been reset. Release the Power button to reset the 
camera. 
 
 

 

 

 

Appendix 

A 

 

 
Note:  You will need to reconfigure your camera settings after resetting the camera. The Veo 
Observer will revert back to the factory default username (admin) and password (password) if the 
camera is reset. The network settings on your camera will also revert back to DHCP, thus, you may 
need to reconfigure the camera using the Observer Setup Utility. Refer to Chapter 5:  Observer 
Setup Utility for directions on configuring the camera’s settings.