Справочник Пользователя для Veo 802.11b

Page 60 of 69 

 
 

 

 
 

1.  Locate the motion sensor connector at the rear of the camera.  The holes for inserting the sensor wires 

are labeled 1 through 4 from left to right. 

2.  Use a small screwdriver to depress and latch down the orange tabs over holes 1, 2 and 4. 
3.  Insert the red wire into hole #1 until the insulation just reaches the back of the camera. 
4.  Use the screwdriver to press down and release the orange tab above hole #1 locking the wire in place. 
5.  Repeat steps 3 & 4 for the white wire (hole #2) and the black wire (hole #4).  
  

 
 
 
 
 
 

 
The sensor is ready for use with the camera.  Reconnect the power supply to the camera and turn the 
camera on.  Refer to Section 3.3: Camera Configuration of the User’s Guide for help configuring the 
camera to work with the sensor. 
 
Notes:   
1.  The range of the sensor is approximately 15 to 18ft and field of view is approximately 45 degrees.   
2.  There is a red LED behind the sensor lens which lights when the sensor is activated. 

Connector #1 

Red 

Connector #2 

White 

Connector #3 

Not used 

Connector #4 

Black