Справочник Пользователя для Pelco EHXM31C22-2

 

C1301M (6/05)

31

 

(See Page 9)

 

The following EHXM unit models feature a window wiper to clear moisture from the window of the 
enclosure: 

EHXM31C22-2

EHXM31C22-2X

EHXM31C22-7

EHXM31C22-7X

EHXM31CBW23-2

EHXM31CBW23-2X

EHXM31CBW23-7

EHXM31CBW23-7X

 

The Wiper menu is only available on the above models. To check the unit model refer to the 

 

 section of this manual. 

 

This feature programs the on/off control for the wiper. There are two available settings for wiper 
control, AUX 1 and Preset 86. If the wiper control is programmed for AUX 1, the wiper will operate 
when AUX 1 is accessed. If the wiper control is set to Preset 86, selecting preset 86 on your 
controller will turn the wiper on/off. 

 

Wiper mode determines how the wiper will act after the wiper control is turned on/off. There are 
two modes of operation for wiper mode: 

MOMENTARY (default)  Programs the wiper to move across the enclosure window once and 

then back to its starting position. 

CONTINUOUS 

Programs the wiper to operate continually after the wiper is turned 
on. The wiper will continue to operate until the wiper control (AUX 1 
or preset 86) is pressed again or until the programmed wiper time is 
completed.

 

The wiper can be programmed to wipe the enclosure window every 2 to 30 seconds. This setting 
only works when the wiper is programmed for continuous mode. The dwell time can be programmed 
from 2 to 30 seconds.

 

Wiper time programs how long the wiper will be on before it automatically shuts off. This setting 
only works when the wiper is programmed for continuous mode. Wiper time can be programmed 
from 60 to 1,440 minutes (1 to 24 hours).

 

CM9700 Matrix Systems Only – For the wiper to operate in continuous mode, the AUX 1 

function in the camera file must be set to latching in the CM9700-MGR. If the AUX 1 camera file is 
not latching, the wiper will only operate in momentary mode, even if the system wiper is 
programmed for continuous operation. Refer to the CM9700-MGR Software Guide for instructions.

<CAMERA>
<OTHER>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<WIPER>
<AUX>
<CLEAR>
<PASSWORD>

BACK
EXIT

UNIT SETTINGS

WIPER CONTROL  

AUX 1

WIPER MODE  

CONTINUOUS

WIPER DWELL (SECS)  

2

WIPER TIME (MINS)  

60

<SET WASHER SEQUENCE>

BACK
EXIT

WIPER*

 * AVAILABLE ONLY WITH THE WIPER MODELS.

EXIT

LANGUAGE  

ENGLISH

<SYSTEM INFORMATION>
<DISPLAY SETUP>
<UNIT SETTINGS>

RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM

PELCO EXSITE EHXM