Справочник Пользователя для Nikon D7000 (18200mm Kit)

228

U

If On is selected when the camera is being used with the built-in 
flash or an optional SB-900, SB-800, SB-700, SB-600, or SB-R200 
flash unit, a modeling flash will be emitted when the camera 
depth-of-field preview button is pressed (

0 72). No modeling 

flash is emitted if Off is selected.

A

M does not appear in the control panel flash sync mode display when – – is selected for Built-
in flash > Mode.

A

The flash compensation value selected with the 

Y (M) button and sub-command dial is 

added to the flash compensation values selected for the built-in flash, group A, and group B 
in the Commander mode menu. A 

Y icon is displayed in the control panel and viewfinder 

when a flash compensation value other than ±0 is selected for Built-in flash > TTL. The 

Y 

icon flashes when the built-in flash is in mode M.

D

Position the sensor windows on the remote flash units to pick up the monitor preflashes 
from the built-in flash (particular care is required if the camera is not mounted a tripod). Be 
sure that direct light or strong reflections from the remote flash units do not enter the 
camera lens (in TTL mode) or the photocells on the remote flash units (AA mode), as this may 
interfere with exposure. To prevent timing flashes emitted by the built-in flash from 
appearing in photographs taken at short range, choose low ISO sensitivities or small 
apertures (large f-numbers) or use an optional SG-3IR infrared panel for the built-in flash. An 
SG-3IR is required for best results with rear-curtain sync, which produces brighter timing 
flashes. After positioning the remote flash units, take a test shot and view the results in the 
camera monitor.

Although there is no limit on the number of remote flash units that may be used, the 
practical maximum is three. With more than this number, the light emitted by the remote 
flash units will interfere with performance.

G button

➜ A Custom Settings menu