Справочник Пользователя для Enterasys Networks X009-U
LEDs and Reset Button
3-40 Matrix X4-C Chassis Setup
The following additional conditions apply:
•
After power up, the fan tray LED remains red until diagnostics begin, then will blink green.
When blinking amber, the fan controller will run a default configuration.
When blinking amber, the fan controller will run a default configuration.
•
An overheating warning indicates fans are running at high speed. Fans operate at normal
speed if no warning is received.
speed if no warning is received.
Module LEDs and Reset Button
Control and Fabric Module LEDs
Two LEDs are provided for CMs and FMs, STATUS and ACTIVE/STANDBY, as shown in
. Additionally, Speed (10/100/1000 Mbps) and Status LEDs on the CM Ethernet RJ45
The CM also provides a Reset button which warm‐reboots the module, suspending service for the
duration of the reboot. If two CMs are installed however, service is not interrupted.
duration of the reboot. If two CMs are installed however, service is not interrupted.
Figure 3-38 Fabric and Control Module LEDs and Reset Button
Caution: If the LED remains red, replace the fan tray immediately. Otherwise, the system may
overheat and damage chassis components.
overheat and damage chassis components.
Precaución: Si observa que la lucecita roja no se apaga, cambie inmediatamente el sistema de
ventilación. Si no lo hace, el sistema se sobrecalentará y los componentes del chasis se dañarán.
ventilación. Si no lo hace, el sistema se sobrecalentará y los componentes del chasis se dañarán.
1 STATUS LEDs
3 RESET button
5 Link LED
2 ACTIVE/STANDBY LEDs
4 10/100/1000 LED
STATUS
ACTIVE/
STANDBY
RESET
ETHERNET
STATUS
ACTIVE/
STANDBY
STANDBY
1
2
2
1
2
3
2
3
4
5
Fabric Module
Control Module