Справочник Пользователя для Panasonic VDR-D220GN

LSQT1161

≥ When about 5 minutes have passed without any operation in recording pause, the unit automatically 

turns off to prevent the battery from running down. When you want to use the unit, turn it on again.
This setting can also be set to [OFF]. (l 84, [POWER SAVE])

A Recording mode
B Remaining time left for recording

(When the remaining time is less than 1 minute, [R 0min] 
flashes red.)

C Recording time elapsed

≥ The maximum number of scenes on a disc (per side): 999 (Even if there is remaining capacity for 

recording on a disc, you may not be able to record 999 scenes.)

≥ Maximum number of dates on a disc (per side): 99 (Even if scenes are recorded on the same day, 

they may be grouped on a different recording date.) (l 60)

≥ Sound is recorded in Dolby Digital from the internal stereo microphone on the front of the unit. Take 

care not to block this microphone.

≥ Each time the unit enters the recording pause mode, the counter display will be reset to “0h00m00s”.
≥ While motion picture recording is in progress, the recording will not stop even if the LCD monitor is 

closed and the viewfinder is retracted.

≥ While “WRITING CONTROL DATA TO DISC. DO NOT SHAKE THE UNIT.” is displayed, do not 

disconnect the AC adaptor or remove the battery as doing so may make the disc unusable.

≥ While motion picture recording is in progress, do not disconnect the AC adaptor or remove the 

battery. If you do, a repair disc message may be displayed when the power is turned back on. (l 89, 
About recovery)

Changing the recording mode of the motion picture.

# [REC MODE] # desired 

The ACCESS/PC lamp lights immediately after recording finishes. While it lights, the disc is rotating 
and disc information is being recorded. If you run while holding the unit or swing it, the recorded 
images may be distorted so do not strongly shake or cause impact to it.

A

B
C

MENU

LSQT1161_GN.book  40 ページ  ２００７年１月１９日　金曜日　午後１時８分