Справочник Пользователя для Panasonic AG-HPX250EN
115
Editing
Writing data on a hard disk drive
1
Switch the mode to USB HOST.
• “Switching to the USB HOST mode” (Page 111)
• The thumbnail screen is displayed.
• The thumbnail screen is displayed.
(USB HOST is displayed in the bottom right.)
2
Connect a hard disk drive via USB.
A hard disk drive that has not been formatted
with the camera-recorder must be formatted
as directed in “Formatting a hard disk drive”
(Page 114).
with the camera-recorder must be formatted
as directed in “Formatting a hard disk drive”
(Page 114).
3
Insert a P2 card.
4
Press the MENU button and select HDD →
EXPORT from the thumbnail menu.
Specify the slot that contains the P2 card
bearing the data to be written to the hard disk
drive.
bearing the data to be written to the hard disk
drive.
5
Select YES.
• This starts the write process.
• When the data is being written, a progress
• When the data is being written, a progress
bar is displayed. To discontinue writing,
press the SET button on the Operation lever
instead of cancellation confirmation.
press the SET button on the Operation lever
instead of cancellation confirmation.
• When the writing is completed, the message
“COPY COMPLETED!” is displayed.
• To disable verification at the time of
writing, select HDD → SETUP from the
thumbnail menu and set the option
VERIFY to OFF. This speeds up writing
without verifying data writing.
• Select ALL SLOT to write data
collectively onto all P2 cards currently
inserted in the unit to the hard disk
drive.
• For a Type-S hard disk drive, data can be
written on a card basis. The data on up
to 23 P2 cards can be stored on the hard
disk drive. The data set on each P2 card is
recognized as a separate drive by the PC.
• If data on a P2 card that contains a
defective clip must be written to a hard
disk drive, then we recommend fixing or
deleting that clip before writing the data.
• When the process is diskontinued during
verification, the data on the P2 card has
been written to the hard disk drive.