Справочник Пользователя для Sony PMW-320K
![Sony](https://files.manualsbrain.com/attachments/7e61ba04cadfce70cb41a1a70ef1d62a30f0a5fe/common/fit/150/50/682a2570dc00831b079177f57c62a2915dd3423eb752334060fbcf750d89/brand_logo.png)
Preparing the Audio Input System
42
Cha
p
te
r 2
P
rep
ar
ar
at
ions
channel on which you want to record
the audio from this microphone to
FRONT.
the audio from this microphone to
FRONT.
4
Secure the microphone cable with the
cable clamp.
cable clamp.
You can connect up to two monaural
microphones to the AUDIO IN CH1/CH2
connectors, using an optional CAC-12
Microphone Holder.
The following is the procedure for attaching an
electret condenser microphone such as the ECM-
674/678.
microphones to the AUDIO IN CH1/CH2
connectors, using an optional CAC-12
Microphone Holder.
The following is the procedure for attaching an
electret condenser microphone such as the ECM-
674/678.
On how to attach the CAC-12, refer to the operation
manual for the CAC-12.
manual for the CAC-12.
1
Attach the electret condenser
microphone.
microphone.
1
Loosen the ball joint lock lever.
2
Wind the microphone spacer (sheet
type, supplied with the microphone)
around the microphone, while peeling
off the protective sheets on both sides
of the microphone spacer.
type, supplied with the microphone)
around the microphone, while peeling
off the protective sheets on both sides
of the microphone spacer.
3
Place the microphone in the holder so
that “UP” is at the top.
that “UP” is at the top.
4
Close the microphone holder.
5
Tighten the screw.
6
Position so that the microphone does
not interfere with the viewfinder and
tighten the ball joint lock lever.
not interfere with the viewfinder and
tighten the ball joint lock lever.
2
Connect the microphone cable to the
AUDIO IN CH1 or CH2 connector.
AUDIO IN CH1 or CH2 connector.
3
Set the switches as follows.
• Set the AUDIO IN selectors indicated
below, depending on the power supply type
of the microphone.
Internal power supply: MIC
External power supply: +48V
of the microphone.
Internal power supply: MIC
External power supply: +48V
• Set the AUDIO IN CH1/CH2 switch for the
channel to which the microphone is
connected to REAR.
connected to REAR.
Connecting Microphones to the
AUDIO IN Connectors
AUDIO IN Connectors
Microphone