Справочник Пользователя для Homelite UT13136

7

Note: Some models are pre-assembled. Assembly is

not needed on these models.
See Saw Chain Tension Adjustment, pages 8 and 9.

1.  Lay chain out flat.
2.  Loosen and remove guide bar nut and sprocket

cover.

3.  Rotate guide bar retainer so that it is positioned

parallel to guide bar slot (see Figure 4).

4.  Install guide bar onto saw body. Assemble center

slot of guide bar onto guide bar bolt and guide bar

retainer.

Note: Make sure the head of the guide

bar retainer slides through the guide bar slot as

shown in Figure 4.

5.  Rotate guide bar retainer 90 degrees as shown in

Figure 5.

6.  Place chain around drive sprocket, along top groove

of guide bar, and around guide bar nose.

Note:

Make sure cutting edges of chain are facing in

right direction. Position chain so cutting edges on

top of guide bar face guide bar nose (see Figure

6 and indicator on side cover of saw).

7.  Insert tab of sprocket cover into slot on unibody

and  rotate  sprocket  cover  onto  guide  bar  bolt

until sprocket cover rests against guide bar (see

Figure 7, page 8).

8.  Place guide bar nut, removed in step 2, on guide

bar bolt.

IMPORTANT: Tighten guide bar nut finger tight

only.

  Device that turns saw on and off. Squeezing

trigger turns saw on. Releasing trigger turns saw off.

  Process of cutting limb(s) from

a living tree.

 An upward cut from underside of log or

limb. This is done while in normal cutting position

and cutting with top of guide bar.

  Main body of chain saw.

Guide Bar Retainer 

Positioned Parallel 

to Guide Bar Slot

Guide Bar Retainer 

Rotated 90 Degrees 

to Guide Bar Slot

Guide Bar

Guide Bar

Drive 

Sprocket

Drive 

Sprocket

Cutting Edge

Towards Guide Bar 

Nose