Справочник Пользователя для VTech VT 9152

10

Pick up the Handset and press PHONE/FLASH. When you hear a dial tone, dial the number.

The IN USE/LOW BATT LED will illuminate when the Handset is in use.

If you make a mistake when dialing, press OFF to hang up, then press PHONE/FLASH to get

a dial tone again.

When the Handset rings, the IN USE/LOW BATT LED will flash on the Handset and the
IN USE/CHARGING LED will flash on the Base Unit. Press any key on the Handset except

OFF. If the Handset is in the Base Unit, simply pick it up to answer the call.

Use the Volume UP and DOWN keys, located on the bottom of the Handset keypad to adjust

the earpiece volume to a comfortable level.

Say “Bye-Bye”, then either press OFF on the Handset, or place the Handset in the Base Unit

cradle.

Press the REDIAL/PAUSE key to dial the last number you called. The Handset must be In

Use for this feature to function.

If you notice noise or interference when using your Handset, press CHAN to switch to a clear

channel. The feature only works when the Handset is in use.

Your 

 is factory preset for TONE dialing. If you require PULSE (ROTARY) dialing,

press PROG/MEM, *, #, PROG/MEM to switch to Pulse dialing. To go back to TONE dialing,
press  PROG/MEM,  *,  *,  PROG/MEM.

If you have rotary (Pulse) service, this feature allows you to enter Tone dialing mode easily.
After making your call, simply press the *TONE key. You are now dialing in TONE mode. Once
you press OFF to end your call, your Handset will revert to Pulse dialing mode.

You can choose among 4 ring styles. You can also turn the Handset ringer off.
•

Press  PROG/MEM

•

Press #

•

Press 1,2,3 or 4  to hear the various styles; or press 5 to turn the Handset ringer off

•

Press PROG/MEM to confirm your choice

•

Press  PROG/MEM

•

Press  #

•

Press  0

•

Press  PROG/MEM to exit