Справочник Пользователя для Mitel 2700-1398-B1

Mitel NuPoint Messenger Technical Documentation - Release 7.0

 

• 

The pager number is limited to 16 characters. The server administrator enters it in a 
mailbox’s configuration. 

For example, you might configure a pager system of T9T, since everyone must dial this to reach 
an outside number. You would then configure the digits of the mailbox owner’s telephone number 
as the pager number when entering a pager message waiting type into the mailbox’s 
configuration. As an alternative, if many mailbox owners have message delivery to the local prefix 
292 you might choose to configure a pager system of T9T292. 

The choice of where to assign each portion of the dial string is flexible. In this example, you have 
three pager systems available, which contain the following dial strings: 

Access Code* 

0 T9T 

2 T9T1408 

4 T 

 

* Same as “Dial String” in the report of outdial indexes, Figure 4-5. 

If the dial string that you have formulated is T9T14085551313++G1234#, you can set up your 
pager number in three different ways, depending on which access code you select: 

0 T9T 

14085551313++G 

1234# 

2 T9T1408 

5551313++G 

++G1234# 

4 T 9T14085551313++G 

++G1234# 

 

* Same as “Dial String” in the report of outdial indexes, Figure 4-5. 

In each of these examples, the individual pager number was put in the post-pager number. You 
can see that the page works no matter how the balance of the string is split between pager and 
post-pager numbers. 

Note:  When designing your paging setup, choose your pager system dial strings carefully. You can only 

refer to 16 pager system access codes 

per server

. 

To use the Pager application, you must configure mailbox parameters as well as offline and 
online parameters. Use this section to see which parameters you must change. You must set 
different mailbox parameters for each capability (paging, message delivery, call placement). The 
specifics of each capability are discussed at the end of this section. 

Since you are configuring the server to outdial, you want it to duplicate the steps that you would 
take to activate the pager, or to place the phone call. You must configure these steps into the 

45