Справочник Пользователя для DMP Electronics SCS-1R

11

The SCS-110 provides power to a maximum of five line cards.  Power is supplied through the modem rack 

backplane connectors without additional cabling.  The SCS-110 also provides LCD and keypad connection, UPS 

system status, and the 120 VAC input monitoring information to the SCS-1R Receiver.

  Always remove power to the SCS-1R Receiver when installing or removing the SCS-110.  

 

Slide the SCS-110 into the modem rack far left hand position, with the card puller up as shown below.  

Plug the flat cable from the membrane keypad PCB onto the card edge connector at the bottom of the 

SCS-110.  The light brown (pin 1) wire of the flat cable connector must face up on the power supply 

card. 

�������

������������������

���

��������

�������

��������

��������

The green LED labeled PWR lights when the power supply to the SCS-110 is working properly.  The red LED labeled 

PWR TRBL is controlled by the SCS-120 Multibus Power Supply Card and lights when there is a power problem on 

the SCS-110.  The red LED remains lit until the power problem is corrected.  The alert tone on the SCS-110 Modem 

Power Supply Card sounds during a power problem and is silenced by pressing the silence switch on the SCS-110.

The LCD Membrane Keypad trouble LED lights and the alert tone sounds when the LCD Membrane Keypad fails to 

operate or the cable is unplugged.  The alert tone is silenced by pressing the silence button on the SCS-110.

The UPS (Uninterrupted Power Supply) trouble LED lights and the alert tone sounds when the UPS Brownout Input 

is opened.  Connect this circuit to the brownout contacts on your UPS system (Refer to SCS-130 information).  No 

End-of-Line resistor is needed.  Silence the alert tone by pressing the silence button on the SCS-110.

The AC trouble LED lights and the alert tone sounds when AC power to the SCS-130 Transformer Card fails.  Silence 

the alert tone by pressing the silence button on the SCS-110.