Справочник Пользователя для Pelco HS2500

 

6

C486M-C (9/06)

 

When a single power source is used for both the camera and accessories, the camera power consumption must be taken into con-

sideration when determining the wire gauge. Also, make certain that all electrical connections are done properly and meet electrical codes.

Before installing the HS2500 to a wall, make certain that the mounting surface is able to support four times the full weight of the enclosure, 
camera, and lens.

The tilt table and tilt table mounting brackets may be removed to provide adequate clearance for mounting the enclosure.

 

The six fasteners required to secure the HS2500 to a wall (minimum 3/8" or 0.95 cm diameter are recommended) are not supplied.

To mount the enclosure to a wall, follow the steps outlined below.

1. Open the enclosure by unscrewing the two tamper-proof screws at the bottom and lifting the cover. A special socket tool is provided 

(fits 1/4" square drive).

2. Using the mounting bracket as a template, mark and drill holes in the mounting surface.

3. Attach the enclosure with the required fasteners.

4. Route the required cables through the back.

5. If you have purchased the optional heater kit, proceed to the 

 

section.

 

The HK8000 and HK8024 heater kits require 120 VAC or 24 VAC respectively, and both provide 80 watts of heat. The heaters are thermostatically 
controlled to activate ON at 40°F (4.44°C) and OFF at 60°F (15.56°C).

The following cable sizes are the minimum recommended for use with heater kits.

 

22 AWG-400 ft (121.92 m) 

20 AWG-35 ft (10.67 m)

20 AWG-650 ft (198.12 m) 

18 AWG-60 ft (18.29 m)

18 AWG-1,100 ft (335.28 m)

16 AWG-80 ft (24.38 m)

To install the HK8000/HK8024, perform the following steps:

1. Open the cover.

2. Attach the heater pads to each side of the tilt table bracket (refer to Figure 1).

3. Press the PC board assembly into the four holes provided in the tilt table bracket.

4. Wire according to the diagram shown in Figure 2.