Справочник Пользователя для Pelco IP3701H-2

C2941M-C  (6/08)

9

Figure 5. Camera Layout

Use the reset button located on the side of the camera to access the following modes:

To access one of these modes:

1. Press and hold the reset button. The unit starts cycling through the modes; hold the button for four 

seconds to access (cycle through) each mode. The unit status indicator flashes the color for the 
current mode (refer to Table A).

2. When the color of the desired mode appears, release the button.

NOTES: 

•

If there is no configuration activity for 15 minutes, the camera will automatically exit the reset 
mode.

•

The LED is not lit during normal operation.

Table A.  Reset LED Status

Configuration

Starts reset LED 
selection sequence.

Flashes green.

Reboot 

Restarts the unit. 

Flashes green and red simultaneously when entering 
this mode. The LED flashes green when mode is 
selected and during reboot.

Reset 

Resets unit to factory 
default settings and 
then restarts unit. 

Flashes red when entering this mode. Flashes red when 
mode is selected, and then flashes green when camera 
restarts. Camera is offline during reset mode. 

Cancel Cancels 

any 

configuration or reset 
action. 

Is not lit.

DIP SWITCHES (COVER REMOVED)

LENS CONNECTOR

BNC VIDEO SERVICE CONNECTOR

BACK FOCUS ADJUSTMENT

LOCKING SCREW

BACK FOCUS

ADJUSTMENT RING

POWER CONNECTOR

NETWORK CONNECTOR

LENS LEVEL ADJUSTMENT

TOP MOUNT 

LEDs

RESET BUTTON