Справочник Пользователя для Pelco HKHS3024
2
Pelco Manual C499M
3.0 INSTALLATION
To install the HKHS3000 and HKHS3024, perform the
following steps.
following steps.
1.
Remove the cover from the enclosure.
2.
Attach the PC board/bracket assembly to the rear
plate using two (2) 1/4-20 nuts and lock washers,
attaching to the studs on the end plate (see Figures
1 and 3).
plate using two (2) 1/4-20 nuts and lock washers,
attaching to the studs on the end plate (see Figures
1 and 3).
3.
Install the heater pads onto the front of the body
(end nearest window) by removing the backing and
pressing in place onto the floor of enclosure (see
Figure 3).
(end nearest window) by removing the backing and
pressing in place onto the floor of enclosure (see
Figure 3).
4.
Wire per the wiring diagram in Figure 2.
Figure 1. Heater Kit Installation
Figure 2. HKHS3000 and HKHS3024 Wiring Diagram