Справочник Пользователя для Pelco es3012

Pelco Manual C306M-K (4/05)

5

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not block any ventilation openings. Install in accordance with the manufacturer’s

instructions.

6. Do not install near any heat sources such as radiators, heat registers, stoves, or other

apparatus (including amplifiers) that produce heat.

7. Only use attachments/accessories specified by the manufacturer.

8. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or

sold with the apparatus. When a cart is used, use caution when moving the cart/appa-
ratus combination to avoid injury from tip-over.

9. Refer all servicing to qualified service personnel. Servicing is required when the appa-

ratus has been damaged in any way, such as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate normally, or has been dropped.

10. Installation should be done only by qualified personnel and conform to all local codes.

11. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P en-

closure, it is designed for indoor use only and it must not be installed where exposed
to rain and moisture.

12. Use only installation methods and materials capable of supporting four times the

maximum specified load.

13. Use stainless steel hardware to fasten the mount to outdoor surfaces.

14. To prevent damage from water leakage when installing a mount outdoors on a roof or

wall, apply sealant around the bolt holes between the mount and mounting surface.

1. AN ALL-POLE MAINS SWITCH with a contact separation of at least 3 mm in each

pole shall be incorporated in the electrical installation of the building.

2. A readily accessible disconnect device shall be incorporated in the building installation

wiring.

3. CAUTION:  These servicing instructions are for use by qualified service personnel

only. To reduce the risk of electric shock do not perform any servicing other that con-
tained in the operating instructions unless you are qualified to do so.

4. Only use replacement parts recommended by Pelco.

5. After replacement/repair of this unit’s electrical components, conduct a resistance

measurement between the line and exposed parts to verify the exposed parts have
not been connected to the line circuitry.

The product and/or manual may bear the following marks:

This symbol indicates that dangerous volt-
age constituting a risk of electric shock is
present within this unit.

This symbol indicates that there are impor-
tant operating and maintenance instructions
in the literature accompanying this unit.

WARNING:  HAZARDOUS MOVING
PARTS. KEEP FINGERS AND OTHER
BODY PARTS AWAY.

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.