Справочник Пользователя для Pelco EH3515K
Pelco Manual C1469M-B (7/99)
3
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
1.
Installation and servicing should only be done by Qualified Service Personnel and
conform to all Local codes.
conform to all Local codes.
2.
Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P en-
closure, it is designed for indoor use only and it must not be installed where exposed
to rain and moisture.
closure, it is designed for indoor use only and it must not be installed where exposed
to rain and moisture.
3.
The weight of the camera/lens and enclosure shall not exceed 20 lbs. – subject to spe-
cific pan/tilt unit.
cific pan/tilt unit.
4.
Only use replacement parts recommended by Pelco.
5.
After replacement/repair of this unit’s electrical components, conduct a resistance
measurement between line and exposed parts to verify the exposed parts have not
been connected to line circuitry.
measurement between line and exposed parts to verify the exposed parts have not
been connected to line circuitry.
6.
The installation method and materials should be capable of supporting four (4) times
the weight of the enclosure, pan/tilt, camera and lens combination.
the weight of the enclosure, pan/tilt, camera and lens combination.
The product and/or manual may bear the following marks:
Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.
and operation.
This symbol indicates that dangerous voltage
constituting a risk of electric shock is present
within this unit.
constituting a risk of electric shock is present
within this unit.
This symbol indicates that there are important
operating and maintenance instructions in the
literature accompanying this unit.
operating and maintenance instructions in the
literature accompanying this unit.
C A U T I O N :
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
DESCRIPTION
The light-duty camera enclosures of the EH3515L Legacy
®
Series are used with Pelco’s
PT480 Series and PT780 Series pan and tilt units. They can be installed indoors or out-
doors.
doors.
The enclosures are constructed of aluminum. The lid is hinged in the front to provide easy
access during installation and when camera/lens adjustments are necessary.
access during installation and when camera/lens adjustments are necessary.
You can install cameras with either fixed focal length lenses or motorized zoom lenses. All
models have an adjustable camera sled to accommodate different sizes of cameras and
lenses. The sled can even be turned over to act as an elevation block.
models have an adjustable camera sled to accommodate different sizes of cameras and
lenses. The sled can even be turned over to act as an elevation block.
You can install a padlock on the rear link-lock latch if additional security is needed.
MODELS
EH3515L
Indoor/outdoor enclosure with lid that opens at the rear. 15-inch
(38.10 cm) length. (CE)
(38.10 cm) length. (CE)
EH3515L-1
EH3515L with 120 VAC heater, defroster, and blower, 27 watts
EH3515L-1HD
EH3515L with 120 VAC heater and defroster, 23 watts
EH3515L-2
EH3515L with 24 VAC heater, defroster, and blower, 25 watts
EH3515L-2HD
EH3515L with 24 VAC heater and defroster, 23 watts
EH3515L-3
EH3515L with 230 VAC heater, defroster, and blower, 32 watts
EH3515L-3HD
EH3515L with 230 VAC heater and defroster, 23 watts