Справочник Пользователя для Pelco EH3515K

Pelco Manual C1469M-B (7/99)

7

Figure 3.  Layout of Circuit Board Traces

Figure 2.  Circuit Board Component Locations

Regularly scheduled maintenance prolongs the operational life and appearance of the
equipment. Clean the window regularly with a soft cloth using a mild, nonabrasive detergent
and water to maintain picture clarity.

If you need to repair the camera enclosure, obtain a service manual in one of the following
ways:
•

Go to Pelco’s web site at 

ftp://www.pelco.com

 and find service manual C478SM.

•

Contact Pelco’s Literature Department and request service manual C478SM.

ELECTRICAL
Input Voltage:

24, 120 or 230 VAC, 50/60 Hz

Electrical
Connections:

One each of the following:
3-connector terminal block for power input
6-pin lens connector
9-connector terminal block for lens wiring
10-connector terminal block for camera and lens wiring
3-pin socket for camera power input
2-pin socket for optional camera power input
2-connector terminal block for blower and defroster
2-connector terminal block for defroster (not used)
2-connector terminal block for heater
BNC for video
BNC for camera synchronization
26-pin RediLINK D-type connector (links enclosure to pan/tilt)

Power Consumption

Heaters:

20 watts total or 10 watts each

Defroster:

3 watts

Blower -1:

4 watts

Blower -2:

2 watts

Blower -3:

9 watts (Blower and resistor are 4.5 watts each for a total circuit power
of 9 watts.)

Ambient Operating
Temperature:

-10° to 120°F (-23° to 49°C)

MECHANICAL
Construction:

Aluminum

Finish:

Gray polyester powder coat

Window:

Lexan

®