Справочник Пользователя для Pelco MC3700 Series
[ 8 ]
Pelco Manual C1987M (6/02)
POWER AND VIDEO CONNECTIONS
MC3700 Series camera is designed to operate from a 12 VDC or 24 VAC power supply. The power supply con-
nections are shown in Figure 4. The LED on the back panel of the camera indicates that power is connected. Use
only a Class 2 isolated power supply. Power consumption is less than 5 watts.
nections are shown in Figure 4. The LED on the back panel of the camera indicates that power is connected. Use
only a Class 2 isolated power supply. Power consumption is less than 5 watts.
Figure 4. Power Supply Connections
To connect the camera power and video:
1. Remove the cosmetic trim ring from the camera (refer to Figure 1). Thread cabling through the rear cover.
2. Connect the power cable to the two pin power connector on the back of the camera using the terminal block
connector (provided). Refer to Table A for the recommend wire gauge and wiring distances.
3. Connect a video cable to the SIGNAL OUT connector (BNC) on the back of the camera. Refer to Table B for
the type of video coaxial cable to use.
4. Reattach the trim ring to the back of the camera.
24 VAC
12 VDC
CLASS 2
ISOLATED
POWER
SUPPLY
CLASS 2
ISOLATED
POWER
SUPPLY