Справочник Пользователя для Pelco C1621M-E (9/08) 3
24
C1621M-E (9/08)
CONNECTING TO THE NETWORK
The NVR5100 Series recorder supports remote administration from an Endura workstation. The NVR5100 is compatible with the entire family of
Endura-ready devices using TCP/IP and UPnP protocols. Consult your network administrator before installing the NVR5100 to avoid possible
network conflicts.
Endura-ready devices using TCP/IP and UPnP protocols. Consult your network administrator before installing the NVR5100 to avoid possible
network conflicts.
The NVR5100 offers the following two network connectors on the rear panel:
•
Primary network connector
Use this Gigabit Ethernet adapter port to connect the NVR5100 to the Endura network. This is required for Endura operation.
•
Secondary network connector
Use this Gigabit Ethernet port to expand the storage capacity of the NVR5100 with one or more SEB5100 storage expansion boxes (refer to
Appendix A: Expanding Video Storage on page 31).
Appendix A: Expanding Video Storage on page 31).
NOTE: For best results, you should only implement an Endura system on a 1000Base-T network. Unless the Endura installation is very small with
a dedicated Endura network, a 100Base-T network will not support the necessary data throughput requirements.
a dedicated Endura network, a 100Base-T network will not support the necessary data throughput requirements.
To connect the NVR5100 to the Endura network using a switched Gigabit Ethernet network:
1. Connect one end of the unshielded twisted pair (UTP) cable to the primary network connector on the NVR5100 rear panel. Use standard
Cat5e or better UTP cable with RJ-45 connectors.
NOTE: Do not connect the UTP cable to the secondary network connector
.
Figure 21. Network Cable Connection
2. Connect the other end of the UTP cable to an available port on a Pelco-approved Gigabit Ethernet switch. Contact Pelco Product Support at
1-800-289-9100 (USA and Canada) or 1-559-292-1981 (international) for a list of approved Gigabit Ethernet switches.
There are two indicators on the network connector on the rear panel. The right indicator glows orange when there is a good connection
between the NVR5100 and a Gigabit Ethernet switch that is powered up. If the indicator does not glow, check the cable and the switch.
Disregard the left indicator, which shows network activity.
between the NVR5100 and a Gigabit Ethernet switch that is powered up. If the indicator does not glow, check the cable and the switch.
Disregard the left indicator, which shows network activity.
PRIMARY NETWORK
CONNECTOR
ENDURA NETWORK
ENDURA NETWORK