Справочник Пользователя для Pelco C3432M-F

C3432M-F (6/08)

31

The IP110 Series Camclosure integrated camera system includes a service connector that outputs camera 
video. Use it at the installation site to set up the field of view and focus the camera.

Figure 25. Service Connector

Pelco offers two optional items (CST150 and ICS-SC) that plug directly into the service connector. Before 
using either option, you must loosen the tamper-resistant screws to remove the trim ring from the back 
box. Use the supplied 1/8-inch hollow screwdriver bit.

The CST150 has a 3-foot (0.9 m) cable and microdisplay for viewing camera video. Plug it into the service 
connector and view the video.

NOTE: The three buttons on the CST150 are not used with the IP110 Series Camclosure.

The ICS-SC has a 4-foot (1.2 m) cable with a service connector and a BNC connector. Plug the service 
connector into the unit. Then connect the other end to any standard BNC (VIDEO IN) connector on a 
monitor.

To assemble a longer service cable for the Camclosure integrated camera system, purchase the following 
from a local electronics supply store:

1

2.5 mm monaural headphone plug

1

CPM 88 miniature coaxial connector

1

RG174/U coaxial cable

To assemble the cable:

1. Attach the CPM 88 miniature coaxial connector to one end of the cable. Follow the directions 

supplied with the miniature coaxial connector.

2. Attach the 2.5 mm monaural plug to the other end of the coaxial cable (refer to Figure 26):

a.

Remove the support sleeve from the plug.

b.

Slip the support sleeve over the end of the cable.

c.

Prepare the cable.

SERVICE
CONNECTOR