Справочник Пользователя для Pelco C2410M-J

6

C2410M-J (2/08)

1. Remove the ceiling tile.

2. Using the adapter plate as a template, cut 

a hole 3.5 inches (9 cm) in diameter in the 
ceiling tile for the back box. Punch four 
screw holes in the ceiling tile. 

3. Attach the back box to the ceiling tile and 

adapter plate with the four 8-32 x 1.25-inch 
screws.

4. Replace the ceiling tile.

5. Remove an adjacent ceiling tile and connect the video cable.

6. Connect the power wires.

•

For 12 VDC, connect the 24 VAC/12 VDC (red) and GND (black) wires to input power. The blue 
wire is not used.

•

For 24 VAC, connect the 24 VAC/12 VDC (red) and 24 VAC (blue) wires to input power. The 
black wire is not used.

1. Some indoor installations do not require a 

heater. If the installation does not require a 
heater, remove the heater board from the 
camera assembly. To remove the heater apply 
pressure and press on the corner of the board.

2. 12 VDC Operation Only: The camera is set 

for 24 VAC operation at the factory. For 
12 VDC operation, remove the jumper from 
the 24 VAC position and install it on the 
12 VDC position.

WARNING: Heater elements could be hot! When camera power is on, use caution when adjusting 
the camera. This applies to all models.

CEILING TILE 

BACK BOX

ADAPTER PLATE

8-32 X 1.25
MOUNTING
HARDWARE
(SUPPLIED)

HEATER
BOARD

24 VAC JUMPER

12 VDC JUMPER

VIDEO
CONNECTOR

HEATER
CONNECTOR