Справочник Пользователя для Sony BRCSDP12

!

!

               

Power 24 VAC, Class 2 Only

Tools Required:  .100" Flat Head Screwdriver
                             Phillips Head Screwdriver

Add thread 
sealing tape

Be sure the bracket is properly and securely mounted 
to a supporting structure capable of rigidly holding the 
weight of the entire unit.  

     

 Using the security tool provided, open the housing by loosen-

         ing the (3) captive security screws located on the housing ring 
         next to the lower clear dome (Figure 2). 

Loosen three 
security screws 
holding dome 

    

  Install the pan/tilt unit quick-release bracket.  It is recom-

         mended that this be done before installing the housing.  
         On the next page are instructions for mounting quick-release 
         brackets from selected manufacturers.

     

 It is recommended that the pan/tilt be installed at this time.

         Connect to the quick-release bracket as shown and
         secure per manufacturer directions.

      

Clean the inside of the dome, with the text-wipe provided.

         Reattach the housing dome and secure the (3) captive screws.  
         Do not overtighten the screws.  Tighten only to the point at 
         which the gap between the ring and the housing top closes. 

 

      Carefully remove the housing from the packaging material.

          Check to be sure all parts are present.

        This unit includes a 1 1/2" NPT housing coupling that can 

           be used with a standard 1 1/2" NPT pipe.  The housing can 
           be used with other brackets designed with 1 1/2" male pipe
           threads, such as the SNCWM20 wall mount bracket.

        Attach the housing coupling to the bracket or pendant pipe 

           (Figure 1).
           NOTE:  Pipe threads should be clean and rust free.   Use a 
                          sealer (such as Tefl on™ tape or silicone sealer) on 
                          the threads. 

©  2003 by Sony Corporation

10/13/04

For BRCSDP12

53 watts at 24 VAC (heater and blower)
Input Connectors:  
          BNC 
          (2) screw-down connectors
          RJ-45 Connector

Refer to the camera's installation guide.

      Mount the housing assembly to the mounting bracket and  

         housing coupling.  A safety cable is included with the housing 
         to temporarily hold it while making wiring connections.  Loop 
         the safety cable over one of the set screws on the housing 
         coupling and make the appropriate connections using the (2) 
         screw-down connectors supplied.

      Undo the safety cable and twist the housing onto the housing

         coupling.  Secure all (3) setscrews provided on the housing 
         coupling (Figure 3).

      Clean the outside of the dome.

Twist and 
Secure